C2362

Redback Manifold Catalytic Converter for Subaru Outback

Redback Manifold Catalytic Converter.

BrandRedbackSWD

Category: Extractors and headers

RRP $1909.00 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Manifold Catalytic Converter for Subaru Outback (10/2000 - 07/ product image

Part specs

SKU
C2362
Supplier
SWD
Category
Extractors and headers
Stock status
In stock at supplier

The Redback C2362 is a manifold catalytic converter for the Subaru Outback, listed from 2000 — exhaust manifold and catalytic converter combined in one bolt-on unit. It's listed at 1909 AUD, supplied by Redback as a direct replacement for the factory part. There's a separate Outback listing under a different part number, so the C2362 must be matched to your exact vehicle.

Matching the right Outback unit

Redback lists more than one manifold cat for the Outback, so the part number matters: the C2362 is its own specific listing and isn't interchangeable on number alone. Because the supplier publishes no engine or series detail beyond the 2000 year reference, we confirm the C2362 is the unit that matches your Outback's head, flange and sensor arrangement before ordering, rather than assuming any Outback cat will do.

What a manifold cat does

This part casts the exhaust manifold and the catalytic converter into a single unit that bolts to the head — the manifold collecting gas from the ports, the converter treating it, with the cat sitting close to the boxer engine to warm up quickly. The C2362 replaces that whole assembly when the converter substrate breaks down, the housing cracks, or collapsed internals begin to rattle.

Is it road legal?

The C2362 is a replacement catalytic converter, not a delete — it restores the emissions hardware the Outback was built with instead of removing it, which is the registration-friendly direction for a road wagon. We confirm the unit suits your vehicle and that the finished exhaust meets NSW requirements; as a manifold cat it's a compliant repair, not an off-road part.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men fits Outback manifold cats across the Illawarra. We confirm the C2362 is the correct unit for your specific Outback, check the flange and sensor ports, then fit it with fresh gaskets so the joint seals clean for the heat. RRP is listed at 1909 AUD; the fitting cost is quoted once the car is with us.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

There are two Outback cats — which is the C2362?
The C2362 is one of the Outback manifold-cat listings, at a list price of 1909 AUD. Because more than one exists, we confirm this part number is the correct match for your specific Outback before ordering.
Is it a cat delete?
No — it's a replacement manifold catalytic converter that restores the factory cat, not a delete.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.