CKIT203

Redback Fitting Kit For Cat for Volkswagen Bora (12/1999 - 05/2008), P

Redback Redback Fitting Kit For Cat.

BrandRedbackSWD

Category: Complete exhaust systems

RRP $37.09 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Fitting Kit For Cat for Volkswagen Bora (12/1999 - 05/2008), P product image

Part specs

SKU
CKIT203
Supplier
SWD
Category
Complete exhaust systems
Stock status
In stock at supplier

The Redback CKIT203 is a catalytic-converter fitting kit listed for the Volkswagen Bora from 1999, priced at a recommended retail of $37.09. Supplied by Redback, it is the mounting and sealing hardware for a cat install, fitted at our Illawarra workshop.

What does fitting a cat actually need?

Dropping a catalytic converter into the Bora's exhaust line is not just the converter — it is also the gaskets, clamps and fasteners that hold it in place and close the joints at each end. The CKIT203 is that supporting hardware, listed to suit the Bora's converter and its mounting points. Redback does not print the individual contents for this listing, so instead of guessing we lay the kit out and check it against your car before fitting.

Will it suit my Volkswagen Bora?

It is listed to fit the Volkswagen Bora from 1999, with two concrete fitment entries recorded. The listing names the make and the era but does not separate engine or trim, so we read it as listed to fit rather than a promise for every build. Send your exact details and we will line them up against the kit before ordering, since fitment feed data can be imperfect.

What happens if the hardware is wrong?

A cat is only as good as the joints around it. The right kit gives sealing faces and fasteners sized for the Bora, so the join holds and you do not get an exhaust leak or a rattle at the cat. A mismatched bolt pattern or thin gasket is where leaks start. Because this is install hardware, there are no diameter, material or sound figures attached to it — it changes nothing about how the exhaust flows or sounds on its own.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits Redback kits like the CKIT203 in-house across the Illawarra. We match the hardware to your cat, renew the gaskets and fasteners as needed, and seal the joints so the line runs tight. Send your Bora details through and we will confirm the listing suits it before booking the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the CKIT203 come with the catalytic converter?
No — it is the fitting hardware only. The converter is bought separately; this kit is what mounts and seals it on the Bora.
Will it fit my Volkswagen Bora?
It is listed to fit the Volkswagen Bora from 1999. Confirm your exact build with the workshop before ordering, as fitment data can be imperfect.
How much is it?
Recommended retail is $37.09, supplied and fitted by Oak Flats Muffler Men in the Illawarra once we confirm it suits your car.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.