E4-NS13-CBS

XForce Performance Exhaust System for Nissan 180SX (01/1988 - 01/1998)

XForce Performance Exhaust System

BrandXForceSWD

Category: Complete exhaust systems

RRP $799.00 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
XForce Performance Exhaust System for Nissan 180SX (01/1988 - 01/1998) product image

Part specs

Pipe Size
3"
Muffler Option
Hotdog (Loud)
System Layout
Cat Back System

The XForce E4-NS13-CBS is a cat-back exhaust system listed to fit the Nissan 180SX from 1988, priced at $799 RRP. It changes the rear half of the system and is sold and fitted at our Illawarra workshop.

What does this cat-back cover?

A cat-back replaces the run behind the catalytic converter through to the tailpipe, leaving the cat and the engine-side pipework as the car left the factory. For this NS13-coded listing the supplier records the cat-back type and the Nissan 180SX fitment from 1988, but not the diameter, material or muffler configuration — so we read those off the kit rather than quoting figures we can't see.

Will it suit my Nissan 180SX?

The slug names the Nissan 180SX and the listing carries two concrete fitment matches from 1988. The supplier leaves the engine and sub-model blank, and feed data can be imperfect, so treat the fit as listed and confirm your exact 180SX build with the workshop before ordering. We'd rather verify it than have a part turn up that doesn't sit right.

What does a cat-back change on a coupe like this?

Behind the cat, the cat-back is where the note and rear flow are set, so swapping it changes the back-half character without touching the emissions hardware up front. On a light rear-drive coupe it tends to give a fuller sound than the original — louder than stock, not a quiet replacement. We hold no sound data for this part, so that's as far as we'll characterise it.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits XForce cat-back systems in-house across the Illawarra. We check the part against your 180SX's hangers and rear layout, fit it square and seal the joins. Send your build and we'll confirm it against the listing before booking the bay; the recommended retail is $799.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the E4-NS13-CBS keep the catalytic converter?
Yes — it's a cat-back, so it changes the section behind the catalytic converter and leaves the factory cat in place.
Will it fit my 180SX?
It's listed to fit the Nissan 180SX from 1988. Confirm your exact engine and build with the workshop, as fitment data can be imperfect.
What does it cost?
The recommended retail price is $799, supplied and fitted at the workshop.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.