FX-720HPC-S

SILVERADO 1500 V8 6.2L 1 7/8in Ceramic Coated Extractors with 3in outlets - Ceramic

SILVERADO 1500 V8 6.2L 1 7/8in Ceramic Coated Extractors with 3in outlets - Ceramic Coated.

BrandMantaMPI Automotive

Category: Extractors and headers

RRP $2483.25 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Generated transparent product-style artwork for FX-720HPC-S SILVERADO 1500 V8 6.2L 1 7/8in Ceramic Coated Extractors with 3in outlets - Ceramic Coated (Silver)

Part specs

SKU
FX-720HPC-S
Supplier
MPI Automotive
Category
Extractors and headers
Vehicle fitment
Chevrolet
Stock status
In stock at supplier

The MPI Automotive FX-720HPC-S is a set of ceramic-coated extractors with 1-7/8in primaries and 3in outlets, finished in silver, listed to fit the Chevrolet Silverado 1500 V8 6.2L. It is a header set that replaces the factory manifolds.

What does this extractor set cover?

This is a tubular extractor (header) set for the 6.2L V8 Silverado 1500. It runs 1-7/8in primary tubes into 3in outlets and wears a silver ceramic coating. The coating is the headline of this variant: a thermal-barrier finish meant to hold heat inside the tube and resist surface corrosion, as opposed to a bare or painted header.

What do ceramic-coated extractors change?

Extractors swap the cast manifolds for tuned tubular runners to scavenge each cylinder more evenly. The ceramic coat is there to keep more heat in the gas stream and off the surrounding engine bay, and to slow rust on the outside of the tube. The trade-off stays honest: tubular headers and a larger outlet run louder than the factory casting, and how loud depends on the system behind them, which we have not measured.

Will it suit my Silverado 1500?

It is listed to fit the Chevrolet Silverado 1500 with the 6.2L V8. The engine and series callouts matter on these trucks, since other Silverado engines use different headers. Confirm your exact build and outlet routing with the workshop before ordering.

What does fitting involve at our Illawarra workshop?

Header work on a full-size truck is a hoist job, with the 3in outlets needing to mate cleanly to the existing or new pipe. Oak Flats Muffler Men supplies and fits the FX-720HPC-S in the Illawarra, checking flange seal, clearance and that the ceramic finish is not damaged during the install.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What primary and outlet sizes does the FX-720HPC-S use?
1-7/8in primary tubes feeding 3in outlets, with a silver ceramic coating.
Why the ceramic coating?
It is a thermal-barrier finish that helps keep heat in the tube and resists surface corrosion, compared with a bare header.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.