FX-852

Suzuki Sierra 1.3L SJ413 Motor 4WD 85-96 Will Not Suit Coil Spring Suspension Extractor

MPI Automotive Suzuki Sierra 1.3L SJ413 Motor 4WD 85-96 Will Not Suit Coil Spring Suspension Extractor.

BrandMantaMPI Automotive

Category: Suspension and 4x4 parts

RRP $455.28 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Suzuki Sierra 1.3L SJ413 Motor 4WD 85-96 Will Not Suit Coil Spring Suspension Extractor product image

Part specs

SKU
FX-852
Supplier
MPI Automotive
Category
Suspension and 4x4 parts
Vehicle fitment
Suzuki
Stock status
In stock at supplier

The MPI Automotive FX-852 is an extractor set listed to fit the Suzuki Sierra 1.3L SJ413 4WD from 1985 to 1996 — and it will NOT suit the coil-spring suspension. That exclusion is the defining detail: this is the set for the non-coil-spring front end.

Coil-spring or not? Read the listing carefully

MPI lists two Sierra extractor sets that differ only by front suspension. The FX-852 is flagged as will-not-suit-coil-spring, so it's routed for the other front-end layout the SJ413 was sold with. Getting this distinction right is the whole point — a set shaped for the wrong suspension fouls the steering or chassis.

What's an extractor and what does it replace?

An extractor set swaps the factory cast manifold for mandrel-bent tubes that give each cylinder its own path out of the head. Against a restrictive cast log on the little 1.3L SJ413, that's a cleaner exit for exhaust gas. We hold no dyno data, so there are no power numbers here — just the part for what it is.

Will it suit my Sierra?

It's listed for the 1.3L SJ413 Sierra 4WD across 1985–1996, specifically the version that will not suit coil-spring suspension. Because the era's Sierras came in more than one front setup, the suspension type is the detail to confirm. Check your exact build with the workshop before ordering.

Fitting at Oak Flats Muffler Men

We fit extractor sets in-house across the Illawarra. The cast manifold comes off, the FX-852 is fitted and sealed to the head, and we check the collector and tubes clear your front end and steering. Bring the Sierra in and we'll match the set to your suspension setup.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What's the difference between the FX-852 and the coil-spring set?
The FX-852 will not suit coil-spring suspension — it's routed for the other front-end layout. There's a separate to-suit-coil-spring extractor for that setup.
Does it fit the SJ413 across 1985–1996?
It's listed to fit the 1.3L SJ413 Sierra 4WD over that range, provided yours isn't the coil-spring front end. Confirm with the workshop.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.