G61408-2564

G61408 2564 Shock Absorber for Ford Ranger T6.2 Next GEN 6cyl. Excluding Raptor UTE

G61408 2564 Shock Absorber.2 Next GEN 6cyl. Excluding Raptor UTE / Dual CAB (G61408-2564) at fits selected vehicle applications. Fast shipping, warranty included.

BrandRAW 4x4

Category: Suspension and 4x4 parts

RRP pending
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
G61408 2564 Shock Absorber for Ford Ranger T6.2 Next GEN 6cyl. Excluding Raptor UTE / Dual CAB product image

Part specs

heights
['0 - 50mm']
positions
['Front']
shock_types
[]
vehicle_count
2

The RAW 4x4 G61408-2564 is the shock absorber listed for the Ford Ranger T6.2 Next-Gen (excluding Raptor), ute dual-cab. As a damper it manages wheel and body movement; pair it with the matching spring rather than expecting it to change height.

What does this shock absorber do?

A shock absorber damps the spring's motion so the tyre stays in contact with the road and the body settles after bumps instead of continuing to oscillate. The G61408-2564 is the replacement damper for the Ford Ranger T6.2 Next-Gen; it manages how quickly the suspension compresses and rebounds rather than supporting load, which is the spring's job. A tired damper shows up as a floaty, bouncy ride and poorer control over corrugations, which is the usual reason one gets replaced.

Front or rear, and what's published?

Shock absorbers are position-specific, and RAW 4x4 hasn't published the length, travel or valving for the G61408-2564 in this listing, so we won't quote a figure or guess the position. We confirm whether it's the front or rear unit, and the correct quantity, against your build with the supplier before ordering.

Does it suit a Ford Ranger T6.2 Next-Gen?

It's listed to fit the Ford Ranger T6.2 Next-Gen (excluding Raptor), ute dual-cab. Damper fitment depends on the exact variant and any lift already fitted, so send us your build and we'll confirm the G61408-2564 is the right shock before we order it in.

Fitting at our Illawarra workshop

Oak Flats Muffler Men fits shock absorbers in-house across the Illawarra. We generally renew dampers in matched pairs across an axle; we swap the unit, check the mounts and bushes, and confirm the ride afterwards.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the G61408-2564 fit my Ford Ranger T6.2 Next-Gen?
It's listed to fit the Ford Ranger T6.2 Next-Gen (excluding Raptor), ute dual-cab. Confirm your exact variant with the workshop before ordering, as shock fitment varies by build and any existing lift.
Does a shock change ride height?
No, a shock controls movement, not height. Ride height is set by the spring. We'd look at springs separately if height is the goal.
Should I replace them in pairs?
We recommend renewing dampers in matched pairs across an axle so both sides behave the same. We can advise on quantity for your setup.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.