K-AMB01828

Unbranded Exhaust System for Ford Falcon (03/1996 - 05/1999)

Unbranded Exhaust System.

BrandUnbrandedSWD

Category: Complete exhaust systems

RRP $377.55 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Unbranded Exhaust System for Ford Falcon (03/1996 - 05/1999) product image

Part specs

Vehicle Make
Ford (FDR004)
Tube Size
060mm (2 3/8") (C11P-1)
Coating
Zinc Plated
Tube Size (Out)
060mm (2 3/8")
Type
U-Bolt
Tube Size (In)
060mm (2 3/8")

The K-AMB01828 is a cat-back exhaust system listed to fit the Ford Falcon built March 1996 to May 1999. It's an unbranded system supplied to us through SWD, covering the run from behind the catalytic converter to the tailpipe.

What does this system cover?

A cat-back system replaces the exhaust from the rear of the catalytic converter back to the tailpipe — the mufflers, mid-pipe and tailpipe, while leaving the cat and everything upstream of it untouched. The K-AMB01828 is listed to fit the Ford Falcon (March 1996 to May 1999). The supplier hasn't published the pipe diameter or the material for this listing, so we confirm those details against the actual part and your car before fitting rather than quoting figures we can't stand behind.

What's a cat-back exhaust and what does it change?

On a cat-back the catalytic converter stays in place, which is why it's the more straightforward swap on a road car — you're changing the muffling and the back half of the system, not the emissions hardware. Compared with a tailpipe-only change it's a fuller replacement, and compared with a full system it stops short of the cat. Expect a different exhaust note to the worn factory unit it replaces; how much depends on the muffler design, which the supplier hasn't detailed here.

Will it suit my Ford Falcon?

This listing is matched to the Ford Falcon, March 1996 to May 1999. Treat that as "listed to fit", not a cast-iron guarantee — feed data can be imperfect, the model spans a long production run, and engine and body variants matter. Send us your build and we'll confirm the exact fitment with the workshop before anything is ordered.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits this system in-house across the Illawarra. It's priced at $377.55 RRP and, being an unbranded part run through SWD, is typically a special-order line rather than a shelf item, so we check current availability when you enquire. We mount it up, check clearances and hanger alignment against your Ford, and tidy any mating joints so it seals properly before you drive away.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the K-AMB01828 fit my Ford Falcon?
It's listed to fit the Ford Falcon, March 1996 to May 1999. Because the listing covers a long production span, confirm your exact variant with the workshop before ordering.
What diameter and material is this system?
The supplier hasn't published the pipe diameter or material for this listing, so we don't quote figures we can't verify. We confirm those details against the actual part when you enquire.
Does this replace the catalytic converter?
No. As a cat-back, it replaces the system from behind the catalytic converter back to the tailpipe and leaves the cat and upstream pipework in place.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.