K-AMB03543

Unbranded Exhaust System for Toyota Prado (07/1996 - 02/2003)

Unbranded Exhaust System.

BrandUnbrandedSWD

Category: Complete exhaust systems

RRP $732.89 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Unbranded Exhaust System for Toyota Prado (07/1996 - 02/2003) product image

Part specs

Vehicle Make
Toyota
Tube Size
063mm (2 1/2")

Listed to fit the Toyota Prado built July 1996 to February 2003, the K-AMB03543 is an unbranded cat-back exhaust supplied through SWD at $732.89 RRP and fitted at Oak Flats Muffler Men in the Illawarra.

How fitting the K-AMB03543 works at our workshop

Oak Flats Muffler Men supplies and fits this Prado cat-back in-house. We start by matching the listed fitment to your wagon, then confirm the rear pipework clears the underbody and hangers under load before the joints are sealed. As an unbranded SWD line at $732.89 RRP it's typically special-ordered, so availability is confirmed at enquiry.

What's a cat-back and what does it leave alone?

A cat-back is the rear of the exhaust, from the catalytic converter back to the tailpipe. Renewing it freshens the rear flow and the note while the converter and the front pipework stay as fitted, so the emissions hardware is left untouched. SWD hasn't published a diameter, material or muffler spec here, so the build is read off the physical kit.

Which Prado does the K-AMB03543 suit?

It's matched to the July 1996 to February 2003 Toyota Prado, with three concrete fitments recorded. That seven-year run crossed engine and body variants, so the date span is "listed to fit" rather than a promise — confirm your exact build with the workshop before we order it in.

Why does an older Prado need the rear section?

On a four-wheel drive of this age the rear muffler and pipework corrode out well before the converter, so the back half is what usually needs renewing. A cat-back does that in a single job. Being unbranded, the part carries no maker's spec sheet, so we verify its build against your Prado on the hoist.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the K-AMB03543 fit my Toyota Prado?
It's listed to fit the Prado from July 1996 to February 2003. Confirm your exact build with the workshop before ordering.
Is it a cat-back or a full system?
A cat-back — it renews the rear section behind the catalytic converter, which stays in place.
What does it cost?
The recommended retail price is $732.89, confirmed with availability when we match it to your Prado.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.