K-RPM15733

Redback Performance Exhaust System for Ford Falcon (09/2002 - 12/2014)

Redback Performance Exhaust System.

BrandRedbackSWD

Category: Complete exhaust systems

RRP $661.03 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Performance Exhaust System for Ford Falcon (09/2002 - 12/2014) product image

Part specs

Tube Size
063mm (2 1/2")
System Layout
Cat Back System
Muffler Option
With Centre & Rear Muffler
Transmission
Both A/M
Coating
Premium Heat-Proof Paint
Vehicle Make
Ford / Mazda (FDG210R)
Length
133mm
Width
98
Pack Size
10
Inside Diameter
65mm

Redback's K-RPM15733 is a cat-back exhaust covering the Ford Falcon built from September 2002 through December 2014, the longest model window in this Falcon range. Listed at $661.03, it renews the system from the catalytic converter to the tailpipe.

Will it suit my Ford Falcon?

This listing spans the Falcon from 09/2002 to 12/2014 — a wide window covering more than a decade of the sedan, so the body, mounts and routing on your car need to be matched against the K-RPM15733 listing rather than assumed. Treat the fitment as listed, not promised: tell us your exact build year and variant and we will check it against the supplier data before the part is ordered.

What part of the exhaust does it replace?

A cat-back is the rear two-thirds of the system, from the catalytic converter back to the tip. The factory cat, front pipe and the emissions hardware up front are left exactly where they are. Redback does not publish a pipe diameter or material for the K-RPM15733, so when the part arrives we measure and confirm the spec against your Falcon rather than quote a figure that isn't in the listing.

What changes when you fit a cat-back?

On a Falcon that has covered the years this one spans, the rear pipework is usually the most corroded part of the system, so the practical gain is fresh, sound pipe and mufflers behind the cat. A cat-back can also shift the exhaust note relative to the worn factory silencer — that is a by-product of the new rear section, not a tuned figure, and we don't quote sound levels the supplier hasn't measured.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men, based in the Illawarra, both orders and fits the K-RPM15733, so the same hands that source it hang it on the hoist, set the tailpipe position and confirm the seal to the factory front section. Across a 09/2002–12/2014 Falcon range the exact car matters, so send your build and we will confirm availability and book a time.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Which Ford Falcon years does the K-RPM15733 cover?
It is listed for the Falcon built from September 2002 to December 2014. Confirm your exact build year with the workshop, as fitment data can be imperfect across a window this wide.
Does fitting this disturb the catalytic converter?
No. It is a cat-back, so everything from the converter forward — including the factory cat — stays in place; only the pipework and mufflers behind it are replaced.
What is the price of the K-RPM15733?
It is listed at $661.03 AUD. As a part for an older Falcon it may be special-order, so check current availability with Oak Flats Muffler Men.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.