K-RPM15742

Redback Performance Exhaust System for Ford Falcon (01/1991 - 09/2002)

Redback Redback Performance Exhaust System.

BrandRedbackSWD

Category: Complete exhaust systems

RRP $773.92 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Performance Exhaust System for Ford Falcon (01/1991 - 09/2002) product image

Part specs

Muffler Option
With Muffler & Hotdog
Coating
Premium Heat-Proof Paint
System Layout
Cat Back System
Transmission
Both A/M
Tube Size
063mm (2 1/2")
Exit
Twin Out
Vehicle Make
Ford / Mazda (FDG210R)
Tube Size (In)
067mm (2 5/8")
Type
U-Bolt
Tube Size (Out)
067mm (2 5/8")

The Redback K-RPM15742 is a cat-back exhaust listed for the Ford Falcon built from January 1991 to September 2002. Priced at $773.92, it renews the system from behind the catalytic converter to the tailpipe.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men in the Illawarra supplies and fits the K-RPM15742 from the one workshop — we mount it on the hoist, set the tailpipe position and check it seals cleanly to the factory front pipe. The listed price is $773.92 AUD. Given the early-1990s reach of this Falcon listing, we confirm availability before ordering, so send your build details through.

Which Falcon years does it cover?

The K-RPM15742 is listed for the Ford Falcon from 01/1991 to 09/2002 — a window spanning more than a decade of the model and several updates. We treat that fitment as a starting point and match your exact build year and variant against the listing before anything is ordered, since feed data can be imperfect.

What is replaced and what stays?

A cat-back replaces the rear of the system — pipe, mufflers and tailpipe — from the catalytic converter back. The cat and the front pipe stay as the factory fitted them. Redback publishes no diameter or material for the K-RPM15742, so we confirm those against the part itself rather than quote an unlisted spec.

What does it change on an older Falcon?

On a Falcon reaching back to 1991, the rear section is usually the most corroded and restrictive part of the exhaust, so the practical result is fresh, sound pipework behind the cat. The exhaust note can shift relative to a worn factory silencer — that is a by-product of the new rear run, not a measured figure we'd put a number on.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the K-RPM15742 suit my Falcon?
It is listed for the Ford Falcon built January 1991 to September 2002. Confirm your exact build year with the workshop before ordering.
Does it touch the catalytic converter?
No. It is a cat-back, so the factory cat stays in place and only the pipework and mufflers behind it are renewed.
Can Oak Flats Muffler Men fit it?
Yes. We supply and fit it at our Illawarra workshop — send your build and we'll book a time on the hoist.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.