K-RPM15745

Redback Performance Exhaust System for Ford Falcon (07/1991 - 09/2002)

Redback Redback Performance Exhaust System.

BrandRedbackSWD

Category: Complete exhaust systems

RRP $737.92 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Performance Exhaust System for Ford Falcon (07/1991 - 09/2002) product image

Part specs

Muffler Option
Centre Muffler Only (Medium)
Coating
Premium Heat-Proof Paint
Tube Size
063mm (2 1/2")
System Layout
Cat Back System
Transmission
Both A/M
Exit
Twin Out
Vehicle Make
Ford / Mazda (FDG210R)
Tube Size (In)
067mm (2 5/8")
Type
U-Bolt
Tube Size (Out)
067mm (2 5/8")

The Redback K-RPM15745 is a cat-back exhaust listed for the Ford Falcon built from July 1991 to September 2002, priced at $737.92. It renews the rear of the system, from the catalytic converter to the tailpipe.

Which Falcon does the K-RPM15745 suit?

This is a single-model listing tied to the Ford Falcon across 07/1991–09/2002 — over a decade of the model in one window. Because Ford updated the car across those years, we read the supplier fitment as listed-to-fit and confirm your exact build year and variant against the K-RPM15745 before ordering.

What does a cat-back swap?

It swaps the rear of the exhaust — pipe, mufflers and tailpipe — from the catalytic converter back, leaving the cat and front pipe untouched. Redback publishes no diameter or material for the K-RPM15745, so we confirm those against the part on the bench rather than quote an unlisted figure.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men in the Illawarra supplies and fits the K-RPM15745 from the one workshop — we hang it, align the tailpipe and check the front-section seal on the hoist. The listed price is $737.92 AUD; for an early-90s Falcon, confirm availability with us first by sending your build.

What does it change on a long-serving Falcon?

On a Falcon reaching back to 1991, the rear section is typically the most corroded and restrictive part of the system, so fitting the K-RPM15745 mainly means fresh, sound pipework behind the cat. The exhaust note may change against a tired factory silencer — a side effect of the new rear run, not a measured figure.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the K-RPM15745 fit my Falcon?
It is listed for the Ford Falcon built July 1991 to September 2002. Confirm your exact build year and variant with the workshop before ordering.
Does it touch the catalytic converter?
No. It is a cat-back, so the factory cat stays in place and only the pipework behind it is replaced.
Can Oak Flats Muffler Men fit it?
Yes. We supply and fit it at our Illawarra workshop — send your build and we'll book it in.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.