KBD12221-XXMR

Toyota Prado 150 Series 2.8L TD (1GD-FTV) June 2015 to current

Toyota Prado 150 Series 2.8L TD (1GD-FTV) June 2015 to current (Factory DPF/Air Purifier Back) - Single 3" Kit.8L Turbo.

BrandPacemaker

Category: Complete exhaust systems

RRP $1304.73 AUD
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Toyota Prado 150 Series 2.8L TD (1GD-FTV) June 2015 to current (Factory DPF/Air Purifier Back) - Single 3" Kit product image

Part specs

SKU
KBD12221-XXMR
Supplier
Pacemaker
Category
Complete exhaust systems
Vehicle fitment
Toyota 150 Series 2.8L Turbo Diesel (GDJ150R)
Stock status
Confirmed on order

The Pacemaker KBD12221-XXMR is a single 3in DPF-back kit listed to fit the Toyota Prado 150 Series with the 2.8L 1GD-FTV turbo-diesel, from 2015. It picks up behind the factory DPF and runs to the tailpipe.

What does this Prado kit cover?

This is a DPF-back run for the 150 Series Prado and its 2.8L 1GD-FTV turbo-diesel, sized as a single 3in pipe from behind the factory diesel particulate filter to the rear. The DPF and everything ahead of it stay in place. Material and muffler details aren't published by Pacemaker for this listing, so we confirm those from the kit rather than quote figures the record doesn't carry.

What is a DPF-back system and what does it change?

DPF-back means the exhaust behind the diesel particulate filter is replaced while the DPF itself stays factory. On a modern diesel like the 1GD-FTV that's the section commonly upgraded for flow without disturbing the filter the vehicle was built with. The honest framing is that it changes the rear of the system; the DPF and the rest of the emissions hardware are left as they are, and no sound figure is published.

Will it suit my 150 Series Prado?

It's listed to fit the Toyota Prado 150 Series with the 2.8L 1GD-FTV turbo-diesel from 2015. Across that production span there are running changes, so we confirm your exact build against the kit before ordering. Fitment is listed to fit, not guaranteed.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits Prado systems in-house across the Illawarra. We mount the kit from the DPF back, set hanger and tailpipe alignment, and check clearances under the body before handing the wagon back.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the KBD12221-XXMR a DPF-back system?
Yes. It replaces the exhaust behind the factory diesel particulate filter and leaves the DPF in place.
Which Prado does it fit?
It's listed to fit the Toyota Prado 150 Series with the 2.8L 1GD-FTV turbo-diesel from 2015. Confirm your build with the workshop.
Is it a 3in system?
Yes, it's a single 3in kit. Material and muffler details aren't published by the supplier, so we confirm them from the kit.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.