KBD4220-XXXX

PY, T6.2 Ford Ranger 2022- On 3.0L V6 Turbo Diesel 3" (DPF Back) Exhaust System

PY, T6.2 Ford Ranger 2022- On 3.0L V6 Turbo Diesel 3" (DPF Back) Exhaust System (SKU: KBD4220-XXXX), $1262.95 from Pacemaker.

BrandPacemaker

Category: Complete exhaust systems

RRP $1262.95 AUD
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
PY, T6.2 Ford Ranger 2022- On 3.0L V6 Turbo Diesel 3" (DPF Back) Exhaust System product image

Part specs

SKU
KBD4220-XXXX
Supplier
Pacemaker
Category
Complete exhaust systems
Stock status
Confirmed on order

The Pacemaker KBD4220-XXXX is a 3in DPF-back exhaust listed to fit the PY (T6.2) Ford Ranger 3.0L V6 turbo diesel, from 2022. This is the standard layout, listed at $1,262.95.

Will it suit my Next-Gen Ranger?

It's listed to fit the PY (T6.2) Ford Ranger, 3.0L V6 turbo diesel, from 2022 — the current Next-Gen V6 ute. Four concrete fitment matches sit behind it. This is the standard DPF-back rather than the diff-dump variant, which carries its own number, so if you're after the standard tailpipe layout this is the one. Feed data isn't perfect, so it's listed to fit; confirm your exact build with the workshop before ordering.

What is a DPF-back and what does this cover?

A DPF-back replaces the exhaust behind the diesel particulate filter through to the tailpipe, leaving the filter and the engine-side hardware where the factory fitted them. KBD4220-XXXX is that rear section, sized at 3in, for the V6 Ranger. It's the route owners take to work the back of the system without touching the filter up front.

Is it road legal?

Because a DPF-back sits behind the diesel particulate filter, the filter stays in place. Road compliance still comes down to the complete vehicle and how it's presented, so confirm the requirements with the workshop and current NSW rules before fitting rather than assuming.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits Ranger DPF-back systems across the Illawarra. We confirm the V6 listing against your actual ute, check the 3in run, tailpipe alignment and hangers for clearances, then book the bay once the build is settled. Where the system needs ordering in, we'll give you the lead time before you commit.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is this the standard or diff-dump version?
This is the standard DPF-back layout. The diff-dump variant uses a separate number, so confirm which you want with the workshop.
Does it remove the diesel particulate filter?
No. As a DPF-back it replaces the exhaust behind the filter, which stays in place.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.