MBT065

Patrol/Maverick GQ 4.2L Cab Chassis Petrol/Diesel (Leaf Spring Model) 2.5in Tail Pipe

Patrol/Maverick GQ 4.2L Cab Chassis Petrol/Diesel (Leaf Spring Model) 2.5in Tail Pipe (MBT065) Fits a wide.

BrandMantaMPI Automotive

Category: Suspension and 4x4 parts

RRP $238.66 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Patrol/Maverick GQ 4.2L Cab Chassis Petrol/Diesel (Leaf Spring Model) 2.5in Tail Pipe product image

Part specs

SKU
MBT065
Supplier
MPI Automotive
Category
Suspension and 4x4 parts
Stock status
In stock at supplier

The MPI Automotive MBT065 is a 2.5in tail pipe listed to fit the leaf-spring GQ Nissan Patrol and Maverick cab-chassis with the 4.2L engine, in petrol or diesel form. It's the rearmost section of the system — the run from the muffler out past the rear axle.

Where does the MBT065 sit in the exhaust?

A tail pipe is the final length of pipe that carries gas from the back of the muffler to the exit point behind the rear axle. On the leaf-spring GQ cab-chassis it has to clear the rear leaf packs and the chassis rails, so it's shaped specifically for that body rather than the coil-spring or wagon variants. At 2.5in it matches the bore the rest of an MPI Patrol system is built around.

Will it suit my GQ Patrol or Maverick?

It's listed to fit the 4.2L GQ Patrol and Maverick cab-chassis on leaf springs, petrol or diesel. The leaf-spring detail matters — coil-spring chassis route the rear of the system differently. Send us your exact build and we'll confirm the MBT065 is the correct tail pipe before ordering.

Is it sold on its own?

Yes — this is a single tail-pipe section, not a full system. It pairs with the matching centre muffler and engine pipe in the MPI 2.5in Patrol range, so it's the part to order if that's the section you're replacing rather than the whole exhaust.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men fits and aligns sections like this in-house across the Illawarra. We check clearances to the leaf springs and chassis, set the hanger positions and seal the joint to the muffler so the fit is clean. Bring the ute in and we'll confirm the section against your build.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the MBT065 a complete exhaust?
No. It's the 2.5in tail pipe only — the rear section from the muffler back. Order the matching centre muffler and engine pipe if you need the rest of the system.
Does it fit a coil-spring GQ?
It's listed for the leaf-spring cab-chassis model. Coil-spring chassis route the rear differently, so confirm your exact setup with the workshop first.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.