MKNI0025

Nissan Navara D40 2.5L Auto Spain With Cat R Tail

Nissan Navara D40 2.5L Auto Spain With Cat R Tail (MKNI0025) Fits NISSAN. Fast shipping, warranty included.

BrandMantaMPI Automotive

Category: Complete exhaust systems

RRP $2456.93 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Nissan Navara D40 2.5L Auto Spain With Cat R Tail product image

Part specs

SKU
MKNI0025
Supplier
MPI Automotive
Category
Complete exhaust systems
Vehicle fitment
Nissan
Stock status
In stock at supplier

Listed at $2456.93, the MPI Automotive MKNI0025 is a with-cat exhaust for the 2.5L automatic Nissan Navara D40 built in Spain. It keeps the catalytic converter and finishes in a rear tailpipe.

What does the MKNI0025 cover?

This is a full system for the Spanish-built D40 Navara with the 2.5L engine and the automatic transmission, set up to retain the catalytic converter and run out to a rear tailpipe. The build origin matters on the D40 because the Spanish and Thai assemblies route differently, which is why MPI lists them as separate part numbers. The bore and material aren't published for this listing, so neither is quoted here — both are confirmed against the ute at fit-up.

Why does the Spanish build get its own listing?

The D40 Navara was assembled in more than one plant, and the under-body layout isn't identical between them, so MPI Automotive matches the system to the build rather than to the model alone. Getting the 2.5L auto Spanish variant right means the cat join, the run and the tailpipe exit all line up the way the factory pipe did. That's why confirming the exact build before ordering matters more on this ute than on a single-source model.

Is the MKNI0025 road legal?

It retains the catalytic converter, which is usually the deciding factor for compliance because road registration in NSW depends on the cat being present. That's not a registration guarantee on its own, so confirm the exact build and any state requirements with the workshop before fitting.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits the MKNI0025 across the Illawarra. We confirm the 2.5L auto, Spanish-build D40 fitment, check the cat join and the tailpipe exit on the hoist, then order the spec in through MPI Automotive once your exact build is confirmed.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the MKNI0025 fit my Nissan Navara?
It's listed to fit the 2.5L automatic D40 Navara built in Spain. The build plant matters on the D40, so confirm your exact variant with the Illawarra workshop before ordering.
Does it keep the catalytic converter?
Yes — it's a with-cat system, so the factory catalytic converter is retained and it finishes in a rear tailpipe.
What does it cost?
It's listed at $2456.93. Contact our Illawarra workshop to confirm availability and lead time.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.