
Patrol Y62 V8 5.6L 3in System, HPC-Extractor, Cats, Centre Hotdog, Rear
MPI AutomotiveRRP$6006.84Patrol Y62 V8 5.6L 3in System, HPC-Extractor, Cats, Centre Hotdog, Rear Tailpipe.
View part
Nissan Patrol Y62 V8 5.6L Wagon 3in Full System-Extractors, Hi Flow Cats, Medium, Sml Centre Muffler.
Category: Extractors and headers


The MPI Automotive MKNI0110 is a 3in full system with extractors, hi-flow cats and a medium/small centre muffler, listed to fit the Nissan Patrol Y62 V8 5.6L wagon. It runs from the engine back, built around the extractors and retaining catalytic converters.
This listing combines extractors, hi-flow cats and a 3in full system with a medium/small centre muffler for the Y62 Patrol V8 wagon. The extractors replace the cast manifolds, the hi-flow cats keep catalytic converters in the system, and the 3in figure is the pipe diameter of the run, finished through a centre muffler the listing describes as medium/small. It's the engine-back package for the 5.6L V8 rather than a tailpipe-only change.
Extractors, also called headers, replace the cast factory manifolds with tubular primaries that merge downstream, aiming to let each cylinder clear with less restriction than a cast manifold. They sit at the front of the system and set up the geometry everything behind them follows — here hi-flow cats, a 3in run and a centre muffler. We hold no flow, power or sound figures for the 5.6L V8 and won't quote any; the honest spec is the extractor set, the hi-flow cats, the 3in system and the medium/small centre muffler, all from the listing.
This listing retains catalytic converters — it runs hi-flow cats rather than deleting them, so it keeps emissions hardware in the system. Whether the build meets NSW road requirements still depends on your exact vehicle and how it's set up, which we'll go through with you. No compliance approval is published by the supplier and we won't imply one; confirm the exact build and any state requirements with the workshop before fitting.
Oak Flats Muffler Men fits extractor-and-full-system packages like this in-house across the Illawarra. We remove the cast manifolds, fit the extractors on fresh gaskets, set the hi-flow cats, hang the 3in run with its centre muffler and check clearances along the Y62 wagon. RRP is listed at 4775.03 AUD; fitting is quoted once we've seen the vehicle.
Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.
Oak Flats Muffler Men can check this part against supplier specs, part number, image, RRP and vehicle details for customers around Oak Flats, Shellharbour, Wollongong, Dapto, Albion Park, Kiama and the northern suburbs.
Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.