NM898-2464

NM898 2464 Shock Absorber Nitro for Ford Ranger PX I & II (t6) UTE / Dual CAB

RAW 4x4 NM898 2464 Shock Absorber Nitro.

BrandRAW 4x4

Category: Suspension and 4x4 parts

RRP pending
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
NM898 2464 Shock Absorber Nitro for Ford Ranger PX I & II (t6) UTE / Dual CAB product image

Part specs

heights
['40mm']
positions
['Front']
shock_types
['nitromax']
vehicle_count
2

The RAW 4x4 NM898-2464 is the -2464 damper in RAW's NM898 line-up for the PX I and II (T6) Ford Ranger dual cab — a nitrogen-charged Nitro shock for one defined fitment on the ute.

Fitting at our Illawarra workshop

Oak Flats Muffler Men fits shock absorbers in-house across the Illawarra. We support the corner, remove the worn shock, fit the NM898-2464 with fresh bushes where needed and torque the mounts, then check the ride. We work in axle pairs so both sides match. Pricing is confirmed on request, as this line can be special-order.

What does the Nitro construction mean?

Nitro is RAW 4x4's name for a nitrogen gas-charged damper, a design meant to keep the oil from foaming and fading when the shock is worked over corrugations or load. It describes the build, not a tested output — our record holds no length, valving or sound figures for the NM898-2464, so we don't quote any.

Does the -2464 suit my Ranger?

It's listed to fit the Ford Ranger PX I and PX II (T6) ute dual cab, a platform shared with the Mazda BT-50 of the period. The NM898 spans several application-specific units, so the suffix matters — tell us your build and the corner you're replacing and we'll confirm the NM898-2464 is the correct one.

Is replacing a shock a compliance issue?

A shock is a suspension wear part, not exhaust or emissions hardware, so exhaust road-legality rules don't apply to a straight swap. If it's part of a lift, the broader NSW modification rules can apply, and we'll talk you through what that means for your Ranger.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

How do I know the NM898-2464 is right for my truck?
The suffix ties it to a specific application on the PX Ranger. Send us your build and corner and we'll confirm before ordering.
Are any performance figures available?
No. It's listed as a nitrogen-charged Nitro damper with no length, valving or sound data published.
Should both sides be done together?
Yes — we fit dampers in axle pairs so the truck stays balanced side to side.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.