PR1110S-2513

PR1110S 2513 Shock Absorber Nitro for Ford Everest UA Wagon

PR1110S 2513 Shock Absorber Nitro.

BrandRAW 4x4

Category: Suspension and 4x4 parts

RRP pending
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
PR1110S 2513 Shock Absorber Nitro for Ford Everest UA Wagon product image

Part specs

heights
['40mm']
positions
['Front']
shock_types
['predator']
vehicle_count
2

Listed for the Ford Everest UA wagon, the RAW 4x4 PR1110S-2513 is a nitro-gas shock absorber for the UA-generation Everest. It replaces a tired factory damper or forms part of a suspension setup on this 4WD wagon.

Why fit a fresh damper?

A shock absorber controls the spring’s movement, so when it softens the Everest starts to float and roll. The PR1110S-2513 is RAW 4x4’s nitro-gas replacement for the Everest UA. A nitro shock carries a nitrogen charge that helps it resist foaming and fade under sustained work, which suits a wagon driven on rough roads or loaded up.

Which Everest is covered?

It is listed for the Ford Everest UA wagon. The UA Everest is the coil-sprung wagon in Ford’s ladder-frame range of the period, so it works the dampers hard. The correct shock depends on your exact build, so confirm your Everest UA spec with the workshop before ordering.

Lift and pricing

This listing doesn’t state a lift height, so we set the PR1110S-2513 to your vehicle’s configuration rather than assuming a raised fit. The recommended retail price isn’t currently published by the supplier, so it may be special-order — we’ll confirm cost and availability on enquiry.

Fitting at our Illawarra workshop

Oak Flats Muffler Men fits RAW 4x4 shocks in-house. We’ll confirm the PR1110S-2513 matches your Everest UA, fit the dampers per axle so both sides stay matched, and inspect the mounts and bushes while we’re under the wagon. Bring it in and we’ll book the work.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the PR1110S-2513 suit the Everest UA?
Yes — it’s listed for the Ford Everest UA wagon. Confirm your exact build with the workshop first.
Is a price listed?
The supplier hasn’t published a price, so it may be special-order. We’ll confirm cost and availability on enquiry.
Should both sides be done together?
We fit dampers per axle so the sides stay balanced, and check the surrounding hardware at the same time.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.