RGP169

RGP169 Bush/shackle/pin/u Bolt KIT for Ford Ranger Pj, PK UTE / Dual CAB (duratorq)

RGP169 Bush/shackle/pin/u Bolt KIT. Quality guaranteed.

BrandRAW 4x4

Category: Suspension and 4x4 parts

RRP pending
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
RGP169 Bush/shackle/pin/u Bolt KIT for Ford Ranger Pj, PK UTE / Dual CAB (duratorq) product image

Part specs

heights
[]
positions
['Rear']
shock_types
[]
vehicle_count
25

The RAW 4x4 RGP169 is a bush, shackle, pin and U-bolt kit listed to fit the Duratorq Ford Ranger PJ and PK ute and dual-cab — the hardware set that renews a leaf pack's mounting points.

What this kit covers

The RGP169 bundles the wear hardware that locates a rear leaf pack: the rubber bushes the spring and shackles pivot on, the shackles and pins that let the pack lengthen as it flexes, and the U-bolts that clamp it to the axle. On a Ranger that's worked hard these parts perish, rattle and corrode together, which is why they're renewed as a set.

Signs the hardware needs renewing

Rear clunk over bumps, vague tracking under load and visibly split bushes or rusted U-bolts all point to tired mounting hardware. Replacing the lot with the RGP169 gets the leaf pack locating cleanly again so new rubber isn't working against hardened old parts — it's the natural companion to any spring or shock job on the PJ/PK.

Fitment for your Ranger

The kit is listed to fit the Ford Ranger PJ and PK with the Duratorq engine in ute and dual-cab form, a platform shared with Mazda in that era. Cab and tray variants can change what's clamped where, so confirm your exact chassis configuration with the workshop before ordering the RGP169.

Fitting at Oak Flats Muffler Men

We fit leaf-spring hardware kits in-house across the Illawarra. While the rear is up we inspect the spring pack and axle seats, press in the new bushes, and torque the U-bolts to spec so the RGP169 locates the pack properly.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What's in the RGP169 kit?
It's a bush, shackle, pin and U-bolt kit for the rear leaf pack of a PJ/PK Duratorq Ranger. Exact contents are confirmed by the workshop for your build.
Why renew this hardware?
Perished bushes and tired U-bolts cause rear clunk and vague tracking. Renewing the set restores clean location of the leaf pack.
Can you fit it with new springs?
Yes — it's the natural companion to spring or shock work, and we do both in one visit at our Illawarra workshop.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.