SSMKCH0008

Camaro 2010 on 5th Gen 6.2L V8 1 3/4in Extractors & 3in Dual Exhaust System with Tips

Camaro 2010 on 5th Gen 6.2L V8 1 3/4in Extractors & 3in Dual Exhaust System with Tips.

BrandMantaMPI Automotive

Category: Extractors and headers

RRP $6328.64 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Camaro 2010 on 5th Gen 6.2L V8 1 3/4in Extractors & 3in Dual Exhaust System with Tips product image

Part specs

SKU
SSMKCH0008
Supplier
MPI Automotive
Category
Extractors and headers
Vehicle fitment
Chevrolet
Stock status
In stock at supplier

The MPI Automotive SSMKCH0008 is a full exhaust system listed to fit the 5th-gen Chevrolet Camaro 6.2L V8 from 2010. It combines 1 3/4in extractors with a 3in dual system and tips.

What does this full system cover?

This is a header-back package for the 5th-gen Camaro: 1 3/4in primary tubular extractors off each bank feeding a 3in dual exhaust, finished with tips. The 1 3/4in figure refers to the extractor primary tube size, and the main run steps out to a 3in dual. It's a complete reworking of the system from the heads back. Material and muffler detail aren't published by the supplier, so we leave those out.

What do the extractors and 3in dual change?

Extractors replace the cast factory manifolds with tubular runners so each cylinder's pulse leaves separately before merging; here the primaries are 1 3/4in. The 3in dual run then carries the gases rearward to the tips. On the 6.2L V8 Camaro from 2010, the SSMKCH0008 addresses the whole system from the heads back rather than just the rear section.

Will it suit my 5th-gen Camaro?

The SSMKCH0008 is listed to fit the 5th-generation Chevrolet Camaro 6.2L V8 from 2010. The 5th-gen run spans several years, so confirm your exact year and build with the workshop before ordering to be sure the routing matches your car.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men fits header-back Camaro systems like this in-house across the Illawarra. The work covers header access at both banks, routing the 3in dual run, and aligning the tips at the rear. Send your build and we'll confirm fitment and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What does the 1 3/4in figure on the SSMKCH0008 mean?
It's the primary tube size of the extractors. The main exhaust run behind them is a 3in dual system finished with tips, listed to fit the 5th-gen Camaro 6.2L V8 from 2010.
Will it fit my Camaro?
It's listed to fit the 5th-generation Camaro 6.2L V8 from 2010. Confirm your exact year and build with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.