E4FAU02CS

Xforce Exhaust for Ford Falcon EA to AU 2.5Inch Cat Back Exhaust

XForce Xforce Exhaust.5Inch Cat Back Exhaust with.

BrandXForceSWD

Category: Complete exhaust systems

RRP $649.00 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Xforce Exhaust for Ford Falcon EA to AU 2.5Inch Cat Back Exhaust with product image

Part specs

Tube Size
063mm (2 1/2")
Vehicle Make
Ford

The XForce E4FAU02CS is a 2.5in cat-back exhaust listed to fit the Ford Falcon EA to AU. It replaces the run from the catalytic converter rearward.

What does this cat-back system cover?

A cat-back replaces the exhaust from the catalytic converter back — the mufflers, pipework and tips — while leaving the factory cat and front pipes in place. This one runs a 2.5in layout across the EA-to-AU Falcon span, a wide range of the older Falcon generations. The material isn't published in our record, so we confirm it at the workshop.

Will it suit my Ford Falcon?

It's listed to fit the Ford Falcon EA to AU, a long range of model codes across the earlier Falcon era. Those covered several drivetrains and body changes, so send the workshop your exact model code, year and variant and we'll confirm this 2.5in cat-back matches your car before ordering.

Is it road legal?

As a cat-back, the E4FAU02CS leaves the factory catalytic converter and any emissions hardware ahead of it untouched. Road compliance still depends on noise and the rest of the build, so confirm any state requirements with the workshop before fitting.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits cat-back systems like this in-house across the Illawarra. We check the 2.5in pipework clears the rear axle and tank, confirm the hangers, and set the tip. Listed to fit the EA-to-AU Falcon; confirm your exact build with us first.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the E4FAU02CS fit my Ford Falcon?
It's listed to fit the Ford Falcon EA to AU. Confirm your exact model code, year and variant with the workshop before ordering.
What pipe size is it?
It's a 2.5in cat-back. The material isn't published in our record, so the workshop can confirm that on request.
Does it keep the catalytic converter?
Yes. It's a cat-back, so it replaces the exhaust from the cat rearward and leaves the factory catalytic converter in place.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.