EVC193L

Ultimate9 Throttle Controller for Land Rover Discovery 3

Ultimate9 Ultimate9 Throttle Controller.

BrandUltimate9SWD

Category: Performance chips and ECU remaps

RRP $299.00 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ultimate9 Throttle Controller for Land Rover Discovery 3 (02/2005 - 12 product image

Part specs

SKU
EVC193L
Supplier
SWD
Category
Performance chips and ECU remaps
Stock status
Order in

For the Land Rover Discovery 3, the Ultimate9 EVC193L throttle controller is listed to fit from 02/2005. It's a plug-in pedal module that reshapes the drive-by-wire accelerator signal, so the throttle responds more sharply to your foot without altering the engine tune.

What does the EVC193L change on a Discovery 3?

The Discovery 3 uses an electronic accelerator pedal, and the factory map tends to favour a smooth, gradual throttle take-up. The EVC193L intercepts that pedal signal and re-maps it before the ECU sees it, so the same pedal travel calls for a more direct throttle opening. On a heavy 4x4 wagon, that translates to a more immediate response off the line and a less laggy feel when you ask for throttle. It's purely a pedal-response change — it doesn't touch fuelling, transmission mapping or the published engine tune.

Discovery 3 fitment from 02/2005

This is the Ultimate9 EVC variant listed to fit the Land Rover Discovery 3 from 02/2005, plugging into the model-specific pedal connector. Because fitment depends on your exact pedal plug and build, send us your Discovery's details and we'll confirm the EVC193L is the right part number before ordering. It's listed to fit rather than guaranteed for every individual variant, so a quick check up front saves trouble later.

Does it add power or affect compliance?

No power, torque or economy figures are published for this controller, and we won't invent any — it's a throttle-response device, not a remap or a power chip. Because it only alters how the pedal signal is interpreted, it doesn't change emissions hardware or the factory tune. If you have questions about your particular setup, raise them with us and we'll talk it through.

Fitting and setup in the Illawarra

Oak Flats Muffler Men fits the EVC193L at our Oak Flats workshop in the Illawarra. It's a plug-in installation at the accelerator pedal using the supplied harness and a compact controller, with no cutting into the factory loom. We'll set it up, confirm the response modes work across the pedal range on your Discovery 3, and show you how to adjust between settings before you leave.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the EVC193L fit my Land Rover Discovery 3?
It's listed to fit the Discovery 3 from 02/2005 via the EVC's vehicle-specific pedal plug. Confirm your exact build with the workshop before ordering.
Does it remap the engine?
No. It only re-maps the accelerator pedal signal for sharper throttle response. The engine tune, fuelling and boost are left as standard.
Can the response be softened again?
Yes. The EVC's settings can be adjusted, including back toward standard, so you can dial the response to suit conditions.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.