hyundai-i30-n-premium-sedan-varex-valved-cat-back-exhaust

Hyundai i30 N Premium Sedan Varex Valved Cat Back Exhaust Special order item

Exhaust Systems Australia Hyundai i30 N Premium Sedan Varex Valved Cat Back Exhaust Special order item.

BrandXForceExhaust Systems Australia

Category: Complete exhaust systems

RRP $1850.00 AUD
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Hyundai i30 N Premium Sedan Varex Valved Cat Back Exhaust **** Special Order Item **** product image

Part specs

SKU
hyundai-i30-n-premium-sedan-varex-valved-cat-back-exhaust
Supplier
Exhaust Systems Australia
Category
Complete exhaust systems
Stock status
Confirmed on order

The Exhaust Systems Australia HYUNDAI-I30-N-PREMIUM-SEDAN-VAREX-VALVED-CAT-BACK-EXHAUST is a bi-modal Varex-valved cat-back listed for the Hyundai i30 N Premium sedan, priced at $1,850 and brought in to order.

Will it suit my i30 N Premium sedan?

This listing is matched specifically to the i30 N Premium sedan — the higher-trim i30 N — so it's tailored to that car's underbody and exhaust routing rather than a generic i30. We treat the listing as listed-to-fit rather than guaranteed, because feed data can be imperfect, and confirm your exact build and trim before ordering. Getting the trim right up front matters on a special-order part.

What does the bi-modal Varex valve do?

The Varex valve opens or closes a path inside the rear muffler, so the system runs closer to stock manners with the valve shut and louder than stock with it open — usually switched from the cabin. That gives one cat-back two characters rather than a single fixed volume, which suits a sedan that pulls daily-driver duty as well as the occasional spirited run. No sound figure is published, so we don't quote one.

Where does a cat-back sit, and what stays factory?

A cat-back replaces the run from the catalytic converter back to the tailpipe — the rear muffler, resonator and pipework — while leaving the cat and the engine-side plumbing in place. On the i30 N Premium that means the rear flow and note change without disturbing the emissions hardware up front, which is why it's the common starting point rather than a full system rebuild.

What does ordering and fitting involve at our Illawarra workshop?

Oak Flats Muffler Men brings this special-order system in for your booking — ask us for the lead time. Once it lands we confirm the i30 N Premium fitment, wire in the valve control, check clearances and hanger alignment, and fit it on the hoist here in the Illawarra.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Which i30 is this for?
It's listed for the Hyundai i30 N Premium sedan, the higher-trim i30 N. Confirm your exact build with the workshop before ordering.
Can I switch between quiet and loud?
Yes. It's a bi-modal Varex valved muffler — closer to stock with the valve closed, louder than stock with it open. We don't publish a sound level.
Is it a stocked part?
No. It's a $1,850 special-order item. Ask the workshop for the current lead time.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.