K-AMB16400

Unbranded Exhaust System for Holden Trax (08/2013 - 08/2019)

Unbranded Unbranded Exhaust System.

BrandUnbrandedSWD

Category: Complete exhaust systems

RRP $685.00 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Unbranded Exhaust System for Holden Trax (08/2013 - 08/2019) product image

Part specs

SKU
K-AMB16400
Supplier
SWD
Category
Complete exhaust systems
Stock status
Order in

The K-AMB16400 is an unbranded cat-back listed for the Holden Trax across 08/2013–08/2019, with a recommended retail of $685 — among the lower-priced systems in this group — supplied through SWD and fitted at Oak Flats Muffler Men in the Illawarra.

What's the Trax fitment here?

This kit is matched to the Holden Trax built 08/2013–08/2019, a six-year window covering the small SUV's main local run. Two concrete fitment entries sit behind it. At $685 RRP it's a budget-end listing; that price is the only hard figure published, with no diameter, material or muffler spec given, so we don't quote those. Across a six-year span the engine and trim options vary, so the listing is a match to confirm.

Where does a cat-back sit on the Trax?

A cat-back is the section behind the catalytic converter — the rear muffler and pipework — and a swap reworks that flow and the note while the converter and front pipes stay as Holden fitted them. On a small SUV like the Trax it's the part that usually corrodes through first, so replacing it targets exactly that without touching the emissions hardware further forward.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits this cat-back in-house. As an unbranded SWD line it's typically special-order, so we check availability when you enquire, confirm your exact Trax matches the listing, then fit it, check clearances and hanger alignment, and seal the joints before you collect it.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the K-AMB16400 fit my Holden Trax?
It's listed to fit the Holden Trax built 08/2013–08/2019. Confirm your exact variant and engine with the workshop before ordering, as the window covers several trim and engine options.
Does it keep the catalytic converter?
Yes. As a cat-back it replaces the run from behind the converter to the tailpipe and leaves the converter and front pipework in place.
What does it cost and who fits it?
The recommended retail is $685. It's supplied unbranded through SWD and fitted at the Oak Flats Muffler Men workshop in the Illawarra.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.