K-RPM14586

Redback Performance Exhaust System for Holden Caprice

Redback Performance Exhaust System

BrandRedbackSWD

Category: Complete exhaust systems

RRP $1700.45 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Performance Exhaust System for Holden Caprice (04/1990 - 06/19 product image

Part specs

Cat Option
with three-way catalytic converter
Header Design
Tuned
Coating
Premium Heat-Proof Paint
System Layout
Engine Back System
Muffler Option
With Centre & Rear Muffler
Transmission
Manual
Tube Size
063mm (2 1/2")
Vehicle Make
Holden
Header Primary Size
038mm (1 1/2")
EGR Fitting
N/A
Header Outlet Size
054mm (2 1/8")
Fits Power Steering
Yes
Fits With Air Conditioning
Yes
Fitting Time [min.]
180
Tube Size (In)
067mm (2 5/8")
Type
U-Bolt
Tube Size (Out)
067mm (2 5/8")

The Redback K-RPM14586 is a cat-back performance exhaust listed for the Holden Caprice from 04/1990, at $1,700.45 RRP — supplied through SWD and fitted at Oak Flats Muffler Men in the Illawarra.

What's specific to this Caprice listing?

The K-RPM14586 is pinned to the Holden Caprice from 04/1990 — an early start date, making this one of the older Holden listings in the range. As the long-wheelbase luxury Holden of the era, the Caprice carries a longer rear exhaust run than a standard sedan, which is the section a cat-back addresses. The $1,700.45 retail is the one published hard figure; diameter, material and muffler configuration aren't given, so we don't state them.

What does a cat-back change on the Caprice?

The cat-back is the part behind the catalytic converter — rear pipework and muffling. Fitting a performance system there changes the rear flow and the note relative to stock while the factory converter ahead of it stays in place. Because Redback hasn't published the bore or material for this listing, we keep to what's recorded and confirm the rest off the part at fitting.

Will it suit my Caprice?

It's listed to fit the Holden Caprice from 04/1990. On a car this age, the exact build and prior repairs matter, so treat the listing as a starting point — send your details and we'll confirm this cat-back suits before ordering.

What does fitting an older Caprice involve at our workshop?

Oak Flats Muffler Men supplies and fits Redback cat-backs like this across the Illawarra. On a 1990-era Caprice we pay particular attention to hanger and bracket condition, mount the K-RPM14586, confirm the longer rear run clears the underbody, and seal it against the factory front section before booking is complete.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the K-RPM14586 fit my Holden Caprice?
It's listed to fit the Holden Caprice from 04/1990. On an older car, confirm your exact build and underbody condition with the workshop before ordering.
Does it keep the catalytic converter?
Yes. As a cat-back it replaces the exhaust from behind the catalytic converter, leaving the factory converter in place.
What does it cost?
The recommended retail is $1,700.45. The workshop confirms current price and availability when you book.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.