K-RPM15639

Redback Performance Exhaust System for Holden Statesman

Redback Performance Exhaust System.

BrandRedbackSWD

Category: Complete exhaust systems

RRP $2615.04 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Performance Exhaust System for Holden Statesman (03/1990 - 06/ product image

Part specs

Transmission
Auto
Cat Option
With Cat
Muffler Option
With Centre & Rear Muffler
Header Design
Tuned
Tube Size
063mm (2 1/2")
System Layout
Engine Back System
Coating
Premium Heat-Proof Paint
Vehicle Make
Holden
Fitting Time [min.]
240
Header Secondary Size
045mm (1 3/4")
Header Primary Size
041mm (1 5/8")
Fits Power Steering
Yes
EGR Fitting
N/A
Header Outlet Size
063mm (2 1/2")
Fits With Air Conditioning
Yes
Length
133mm
Width
98
Pack Size
10
Inside Diameter
65mm
Tube Size (In)
067mm (2 5/8")
Type
U-Bolt
Tube Size (Out)
067mm (2 5/8")

The Redback K-RPM15639 is a cat-back exhaust listed to fit the Holden Statesman from 1990, at an RRP of $2615.04. It renews the exhaust from the catalytic converter rearward.

What does fitting the K-RPM15639 involve at Oak Flats?

At our Illawarra workshop the Statesman goes on the hoist first, where we inspect the existing system. The K-RPM15639 is then fitted from the catalytic converter back, and we check the cat joint, hangers and tailpipe clearances on the long-wheelbase body before the car comes down. At $2615.04 it is usually ordered in, so we confirm stock with you first.

Will it suit my Holden Statesman?

It is listed to fit the Holden Statesman from 1990. Fitment data on cars this age is not always exact, so we confirm the model, body and any earlier exhaust work before ordering the K-RPM15639. A long-wheelbase Holden that has had patch repairs over the years can sit differently to an original car, which is the sort of detail we want to settle first.

What is a cat-back replacing here?

A cat-back takes over from the catalytic converter and runs through the mufflers to the tailpipe, leaving the cat and front pipe standard. On a heritage Statesman that renews the corroded rear half without disturbing the emissions hardware. Redback publish no pipe diameter or material grade for it.

Does it change the sound?

Renewing the rear silencing typically gives a fuller note than a worn factory muffler. The result varies by car, and Redback list no sound data, so we will not quote a figure.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the K-RPM15639 fit my Holden Statesman?
It is listed to fit the Holden Statesman from 1990. Confirm your exact variant with the workshop first, as fitment data can be imperfect.
Does it replace the catalytic converter?
No. As a cat-back it leaves the converter and front pipe in place and renews the pipework behind them.
Is it in stock?
It is listed at $2615.04 and is usually ordered in for these heritage Statesmans; we confirm availability first.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.