K-RPM15645

Redback Performance Exhaust System for Holden Caprice

Redback Redback Performance Exhaust System.

BrandRedbackSWD

Category: Complete exhaust systems

RRP $1576.39 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Performance Exhaust System for Holden Caprice (09/1997 - 08/20 product image

Part specs

Cat Option
with three-way catalytic converter
Header Design
Tuned
Coating
Premium Heat-Proof Paint
Transmission
Both A/M
Muffler Option
With Centre & Rear Muffler
System Layout
Engine Back System
Tube Size
063mm (2 1/2")
Vehicle Make
Holden
Fits Power Steering
Yes
Fits With Air Conditioning
Yes
Header Primary Size
038mm (1 1/2")
EGR Fitting
N/A
Header Outlet Size
054mm (2 1/8")
Fitting Time [min.]
180
Tube Size (In)
067mm (2 5/8")
Type
U-Bolt
Tube Size (Out)
067mm (2 5/8")

The Redback K-RPM15645 is a cat-back exhaust listed to fit the Holden Caprice from 1997, with an RRP of $1576.39. It covers the system from the catalytic converter back to the tailpipe.

What does the K-RPM15645 cover?

As a cat-back, it takes over from the catalytic converter and runs through the mufflers to the tailpipe. The cat and front pipe are left as Holden fitted them, so on a late-1990s Caprice this renews the rear half of the exhaust while keeping the factory emissions hardware. It is the rear section rather than a full engine-back system. Redback do not publish a pipe diameter or material grade for it.

Will it suit my Holden Caprice?

It is listed to fit the Holden Caprice from 1997. Even on a newer heritage car the fitment data can be imperfect, so we confirm the model, body and any earlier exhaust work before ordering the K-RPM15645 in, checking it lands cleanly on the converter flange.

What does fitting it involve at our Illawarra workshop?

Oak Flats Muffler Men put the Caprice on the hoist, remove the old rear section and offer up the K-RPM15645 from the converter back, checking the cat joint, hangers and clearances along the long body. At $1576.39 it may be ordered in, so we confirm stock first.

Will it sound different?

Renewing the rear silencing usually gives a fuller note than a worn factory muffler. The result depends on the car, and Redback publish no sound data, so we describe it rather than quote a figure.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the K-RPM15645 fit my Holden Caprice?
It is listed to fit the Holden Caprice from 1997. Confirm your exact variant with the workshop first, as fitment data can be imperfect.
Does it include the catalytic converter?
No. It is a cat-back, so it renews the pipework, mufflers and tailpipe behind the converter and leaves the cat and front pipe in place.
What does it cost?
The K-RPM15645 is listed at $1576.39 and may be ordered in; we confirm availability before you commit.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.