K-RPM15712

Redback Dual 2.5" Catback Exhaust for Holden Commodore VX VT VY VZ V8 LS1 5.7L

Redback Redback Dual 2.5" Catback Exhaust.7L And Supercharged V6 Sedan.

BrandRedbackRedback Exhausts

Category: Complete exhaust systems

RRP $656.55 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Dual 2.5" Catback Exhaust for Holden Commodore VX VT VY VZ V8 LS1 5.7L And Supercharged V6 Sedan product image

Part specs

SKU
K-RPM15712
Supplier
Redback Exhausts
Category
Complete exhaust systems
Vehicle fitment
holden
Stock status
In stock at supplier

The Redback K-RPM15712 is a dual 2.5in cat-back exhaust listed to fit the Holden Commodore VX, VT, VY and VZ V8 (LS1 5.7L) and supercharged V6 Sedan. It replaces the system from behind the catalytic converter rearward.

What does this system cover?

This is a dual 2.5in cat-back run for the VX, VT, VY and VZ Commodore Sedan, covering the V8 LS1 5.7L and the supercharged V6. It replaces the exhaust from behind the catalytic converter to the tailpipe and leaves the factory cat in place. The material isn't published in the record, so that detail is confirmed by the workshop rather than claimed here.

What is a dual cat-back system and what does it change?

A cat-back is the section behind the catalytic converter — the centre and rear pipework, mufflers and tailpipes. Running it as a dual 2.5in layout gives twin paths and twin outlets at the rear, while keeping the factory cat. On these V8 and supercharged-V6 sedans it changes the rear of the system rather than the emissions hardware. The trade-off is that it alters flow and the note from the cat back only — louder than stock — and the twin routing is confirmed on the car.

Will it suit my Commodore?

It's listed to fit the Holden Commodore VX, VT, VY and VZ Sedan in V8 LS1 5.7L and supercharged-V6 form, with four concrete fitment entries recorded. That's a broad platform span, so send your exact variant and engine and we'll confirm the dual 2.5in routing before ordering.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men fits dual cat-back systems like this in-house across the Illawarra. We confirm the cat connection, hanger points and rear clearance on your Commodore, then book the bay. Recommended retail is $656.55.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What does the K-RPM15712 replace?
It's a dual 2.5in cat-back, so it replaces the exhaust from behind the catalytic converter to the tailpipe. The factory cat stays in place.
Which Commodores does it fit?
It's listed to fit the VX, VT, VY and VZ Sedan in V8 LS1 5.7L and supercharged-V6 form, with four concrete fitment entries. Confirm your exact build with the workshop.
What diameter is it?
It's a dual 2.5in system, the figure published in the listing.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.