K-RPM15721

Redback Performance Exhaust System for Holden Statesman

Redback Performance Exhaust System.

BrandRedbackSWD

Category: Complete exhaust systems

RRP $733.29 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Performance Exhaust System for Holden Statesman (09/1997 - 09/ product image

Part specs

Exit
Twin Out
Muffler Option
Centre Muffler Only (Medium)
Tube Size
063mm (2 1/2")
Coating
Premium Heat-Proof Paint
Transmission
Both A/M
System Layout
Cat Back System
Vehicle Make
Holden
Length
133mm
Width
98
Pack Size
10
Inside Diameter
65mm
Tube Size (In)
067mm (2 5/8")
Type
U-Bolt
Tube Size (Out)
067mm (2 5/8")

The Redback K-RPM15721 is a cat-back exhaust listed for the Holden Statesman from 1997, with a $733.29 AUD RRP. Being a cat-back, it changes the piping aft of the catalytic converter and keeps the front of the system standard.

What does the workshop do with this kit?

Oak Flats Muffler Men is the seller and the fitter, so the K-RPM15721 is ordered, hung and checked by the same Illawarra crew. We raise the Statesman on the hoist, offer the rear section up, confirm clearance along the underbody and seat the hangers before signing it off. Book the car in and the supply-and-fit runs through one door.

Which Holden is the K-RPM15721 listed to?

This listing points to the Holden Statesman from 1997 — the long-wheelbase flagship of that period. The make is Holden and the model on this listing reads as the Statesman; no engine or series is published against it, so we will not assume one. Likewise no bore size or material is given, and we confirm both off the part when it lands rather than quote figures the supplier has not.

Where does a cat-back fit in the picture?

A cat-back is the rear span of the exhaust — the part behind the catalytic converter. Replacing it leaves the cat and the front pipe factory, which keeps the emissions hardware as Holden built it while freshening the section most owners change. It is the least invasive of the upgrade options. Any change in note is down to that rear run, and we do not put a number on sound the supplier has not measured.

Will it match your Statesman?

It is listed to fit, drawn from supplier fitment data rather than measured against your individual car. Long-wheelbase Holdens varied through their run, so send your build year and driveline and we will check the K-RPM15721 against your Statesman before placing the order.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the K-RPM15721 suit my Holden Statesman?
It is listed to fit the Holden Statesman from 1997. Confirm your exact build with the workshop, as fitment data can be imperfect.
Does it touch the cat?
No. A cat-back replaces only the run behind the catalytic converter.
Can you fit it at your workshop?
Yes. We supply and fit it at Oak Flats Muffler Men in the Illawarra and book the hoist once your build is confirmed.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.