K-RPM15723

Redback Performance 2.5" Exhaust System for Holden Commodore VN VP VR

Redback Performance 2.5" Exhaust System

BrandRedbackSWD

Category: Complete exhaust systems

RRP $374.48 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Performance 2.5" Exhaust System for Holden Commodore VN VP VR product image

Part specs

Coating
Premium Heat-Proof Paint
Muffler Option
Centre Muffler Only (Medium)
Transmission
Both A/M
System Layout
Cat Back System
Tube Size
063mm (2 1/2")
Vehicle Make
Holden
Tube Size (In)
067mm (2 5/8")
Type
U-Bolt
Tube Size (Out)
067mm (2 5/8")
Length
133mm
Width
98
Pack Size
10
Inside Diameter
65mm

Priced at $374.48 AUD, the Redback K-RPM15723 is a 2.5in cat-back exhaust listed for the Holden Commodore in VN, VP and VR forms. The 2.5in sizing is stated on the listing, and the system runs from the catalytic converter rearward.

Where does a cat-back sit on the VN-to-VR Commodore?

Think of the exhaust in three blocks — front pipe, mid, and the cat-back rear. The K-RPM15723 is that rear block, a 2.5in run behind the catalytic converter, with the cat and front plumbing left as Holden built them. It is the most contained of the exhaust upgrades, which is why owners of these early-90s Commodores often start here. The note follows the rear section, and we do not state a sound level the supplier has not measured.

Which Commodores does the K-RPM15723 list to?

Redback lists this 2.5in kit across the Holden Commodore VN, VP and VR — three closely related series from the early 1990s. They share enough underneath to sit under one SKU, but individual trims and drivelines differed, so the listing is a guide to verify rather than a cast guarantee. No material is published, and we confirm that against the part.

How do we confirm the match?

It is listed to fit the VN, VP and VR Commodore, but feed data is not the same as eyes on your car. Send Oak Flats Muffler Men your exact series and engine and we will line the K-RPM15723 up against it before any order is placed.

What does fitting involve here?

We supply and fit this 2.5in system in-house across the Illawarra. On the hoist we check it clears the underbody and the hangers seat cleanly on your Commodore, then book the job. Same workshop orders it and fits it.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the K-RPM15723 fit the VN, VP and VR?
It is listed across all three series. Confirm your exact Commodore with the workshop, as fitment data can be imperfect.
What size is the pipe?
The listing specifies 2.5in for this cat-back.
Can you supply and fit it?
Yes. Oak Flats Muffler Men supplies and fits it in the Illawarra; the RRP is $374.48 AUD.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.