K-RPM15727

Redback Performance Exhaust System for Holden VL Commodore Sedan (03/1986 - 09/1988)

Redback Performance Exhaust System.

BrandRedbackRedback Exhausts

Category: Complete exhaust systems

RRP $466.58 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Performance Exhaust System for Holden VL Commodore Sedan (03/1986 - 09/1988) product image

Part specs

SKU
K-RPM15727
Supplier
Redback Exhausts
Category
Complete exhaust systems
Vehicle fitment
holden
Stock status
Order in

Priced at $466.58 AUD, the Redback K-RPM15727 is a cat-back exhaust listed for the Holden VL Commodore sedan built 1986 to 1988. The cat-back run picks up behind the catalytic converter and keeps the factory front pipework.

How does fitting run at the Illawarra workshop?

Oak Flats Muffler Men is both the supplier and the fitter, so the K-RPM15727 is ordered, hung and checked by the same crew. We raise the VL sedan on the hoist, offer the rear section up, confirm it tracks clear and seat the hangers before it is signed off. Booking is the only step needed — supply through fitting happens in the one Illawarra shop.

Which VL Commodore is the K-RPM15727 listed to?

This listing is keyed to the sedan body of the Holden VL Commodore across its 1986-to-1988 production. That is a tightly defined car — one body, one short window — but driveline and trim still varied, so the listing remains a fitment guide to verify. No bore size or material is published on this SKU, and we confirm both off the kit.

What does the cat-back change on a VL sedan?

On the VL Commodore sedan, the cat-back swaps the exhaust section behind the catalytic converter and leaves the cat and front pipe as Holden built them. It is the least invasive exhaust change — the rear run only. That keeps the emissions hardware factory while freshening the back half. The tone shifts with that section, and we do not quote a loudness figure the supplier has not measured.

Will it match your car?

It is listed to fit the 1986-to-1988 VL sedan, taken from supplier fitment data rather than measured against your car. Send your build year and driveline and we will check the K-RPM15727 against your exact VL before placing the order.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Which years does the K-RPM15727 cover?
It is listed for the Holden VL Commodore sedan built 1986 to 1988. Confirm your exact build with the workshop.
Is the cat removed?
No. A cat-back only replaces the piping behind the catalytic converter.
Can you supply and fit it?
Yes. Oak Flats Muffler Men supplies and fits it in the Illawarra; the RRP is $466.58 AUD.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.