K-RPM15731

Redback Performance 2.5" Exhaust System for Holden Commodore VN VP VR

Redback Performance 2.5" Exhaust System.

BrandRedbackSWD

Category: Complete exhaust systems

RRP $474.48 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Performance 2.5" Exhaust System for Holden Commodore VN VP VR product image

Part specs

Transmission
Both A/M
Coating
Premium Heat-Proof Paint
System Layout
Cat Back System
Muffler Option
With Centre & Rear Muffler
Tube Size
063mm (2 1/2")
Vehicle Make
Holden
Length
133mm
Width
98
Pack Size
10
Inside Diameter
65mm
Tube Size (In)
067mm (2 5/8")
Type
U-Bolt
Tube Size (Out)
067mm (2 5/8")

The Redback K-RPM15731 is a 2.5in cat-back exhaust listed for the Holden Commodore in VN, VP and VR forms, with a $474.48 AUD RRP. The 2.5in sizing comes from the listing, and the system runs from the catalytic converter back.

How is the K-RPM15731 fitted at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits this 2.5in kit under one roof. We raise the Commodore on the hoist, offer the rear section up, confirm it tracks clear along the underbody and seat the hangers before signing it off. Because we order and fit it ourselves, there is no gap between the parts side and the bay.

Which Commodores does it list to?

This listing is keyed to the Holden Commodore VN, VP and VR — the early-1990s series of Holden's mainstream car. It is supplied as a 2.5in cat-back. No engine or material is published against this particular listing, so we will not name either; both are confirmed off the part when it arrives.

What does a 2.5in cat-back change?

A cat-back is the rear run of the exhaust, here at 2.5in, taken from the catalytic converter back. It leaves the cat and the front pipe factory, so the emissions hardware stays as Holden set it. It is the least disruptive exhaust option — the section owners most often change. The tone follows that rear run, and we do not state a loudness figure the supplier has not published.

Is the fit confirmed for your car?

It is listed to fit the VN, VP and VR Commodore, drawn from supplier data rather than measured against your car. Trims and drivelines varied across the three series, so send your exact build and we will verify the K-RPM15731 before ordering.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the K-RPM15731 fit the VN, VP and VR?
It is listed across all three series as a 2.5in cat-back. Confirm your exact Commodore with the workshop.
Is the cat retained?
Yes. A cat-back changes only the section behind the catalytic converter.
Can you fit it for me?
Yes. Oak Flats Muffler Men supplies and fits it in the Illawarra; the RRP is $474.48 AUD.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.