K-RPM15731

Redback Performance 2.5" Exhaust System for Holden Commodore VN VP VR V6 & V8 & VS V8

Redback Performance 2.5" Exhaust System.

BrandRedbackRedback Exhausts

Category: Complete exhaust systems

RRP $474.48 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Performance 2.5" Exhaust System for Holden Commodore VN VP VR V6 & V8 & VS V8 Sedan product image

Part specs

SKU
K-RPM15731
Supplier
Redback Exhausts
Category
Complete exhaust systems
Vehicle fitment
holden
Stock status
Order in

The Redback K-RPM15731 is a 2.5in cat-back exhaust listed for the Holden Commodore sedan in VN, VP and VR (V6 and V8) and VS V8 forms, priced at $474.48 AUD. The 2.5in bore is stated on the listing, and the run starts behind the catalytic converter.

What drivelines and bodies does the K-RPM15731 list to?

This is a broad sedan listing: the Holden Commodore VN, VP and VR in both V6 and V8, plus the VS in V8 — all in sedan form, all in 2.5in pipe. The V6 is named in the fitment data, and V8 variants appear across the series. With several drivelines under one SKU, the listing reads as a shortlist to confirm against your particular car.

Why a 2.5in cat-back on these Commodores?

The cat-back is the rear span of the exhaust, here in 2.5in, taken from the catalytic converter back. Across these VN-to-VS sedans it leaves the cat and front pipe factory and changes only the section behind. It is the contained end of an exhaust upgrade. No material is published on this SKU, and the note follows that rear run — we do not attach a sound figure the supplier has not measured.

Will it match my V6 or V8 sedan?

It is listed to fit the named V6 and V8 sedans across the VN, VP, VR and VS, drawn from supplier data. Driveline matters on fit, so send Oak Flats Muffler Men your exact series and engine and we will line the K-RPM15731 up against it before ordering.

How is it supplied and fitted in the Illawarra?

We supply and fit this 2.5in system in-house. On the hoist we check it clears the underbody of your Commodore sedan and seat the hangers, then book the job. The same crew orders the part and hangs it.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the K-RPM15731 cover both V6 and V8 Commodores?
It is listed for VN, VP and VR in V6 and V8 and the VS in V8, all in sedan form. Confirm your exact driveline with the workshop.
Is it a 2.5in system?
Yes. The listing specifies a 2.5in cat-back.
What does it cost?
The listed RRP is $474.48 AUD, with fitting quoted separately.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.