K-RPM15767

Redback Performance Exhaust System for Holden Caprice (04/1990 - 02/1994), Holden

Redback Performance Exhaust System.77 RRP

BrandRedbackRedback Exhausts

Category: Complete exhaust systems

RRP $586.77 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Performance Exhaust System for Holden Caprice (04/1990 - 02/1994), Holden Caprice (04/1990 - 02/1994) product image

Part specs

SKU
K-RPM15767
Supplier
Redback Exhausts
Category
Complete exhaust systems
Vehicle fitment
holden
Stock status
Order in

The Redback K-RPM15767 is a cat-back exhaust listed for the Holden Caprice from 1990, catalogued at a recommended retail of $586.77.

What does this Caprice listing include?

This K-RPM15767 entry names the Holden Caprice from 1990 and prices it at $586.77. Being a cat-back, the part runs from the catalytic converter back to the tailpipe; the cat and front pipe are not part of it. No diameter, material or muffler spec is published by Redback for this listing, so we keep to what is recorded and read the rest off the kit at fitting.

What does a cat-back actually change?

A cat-back is the rear half of the exhaust, the run a workshop reaches for when the back of an older system has corroded or gone dull. Renewing it on a long-owned Caprice replaces the rear pipework and silencing and shifts the note against a tired factory muffler, while the emissions gear up front stays standard. The honest trade-off is fresh pipe and a changed tone, not an output claim — the record carries no sound or power data.

Will it suit my Holden Caprice?

It is listed to fit the Holden Caprice from 1990. Variations across the Caprice's build can still decide whether a given kit lines up, so we confirm rather than assume. Send us your exact Caprice and we will verify the K-RPM15767 against it before ordering it in.

Is it road legal, and what does fitting involve?

As a cat-back it leaves the factory catalytic converter and emissions hardware in place, and the record flags no cat-delete — so confirm any state-registration detail for your Caprice with us first. Oak Flats Muffler Men then fits it across the Illawarra: we match the K-RPM15767 to your car, check the rear pipework clears the underbody and hangers, set the tailpipe and book the bay. On a 1990 Holden, availability is worth a call first.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the K-RPM15767 keep the catalytic converter?
Yes. It is a cat-back, so it replaces the exhaust from the catalytic converter rearward and leaves the factory cat in place.
What does it cost?
The recommended retail is $586.77, confirmed once we match it to your Caprice.
Will it fit my Caprice?
It is listed to fit the Holden Caprice from 1990. Confirm your exact build with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.