K-RPT14626

Redback Performance Exhaust System for Holden Calais

Redback Performance Exhaust System.

BrandRedbackSWD

Category: Complete exhaust systems

RRP $2103.35 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Performance Exhaust System for Holden Calais (01/1988 - 04/199 product image

Part specs

Transmission
Auto
Tube Size
063mm (2 1/2")
Header Design
Tuned
Muffler Option
Centre Muffler Only (Medium)
Coating
Premium Heat-Proof Paint
System Layout
Engine Back System
Cat Option
With Cat
Vehicle Make
Holden
Fitting Time [min.]
180 (RBH032)
Header Primary Size
041mm (1 5/8")
Fits Power Steering
Yes
EGR Fitting
N/A
Fits With Air Conditioning
Yes
Header Outlet Size
063mm (2 1/2")
Header Secondary Size
051mm (2")
Length
133mm
Width
98
Pack Size
10
Inside Diameter
65mm
Tube Size (In)
067mm (2 5/8")
Type
U-Bolt
Tube Size (Out)
067mm (2 5/8")

The Redback K-RPT14626 is a cat-back performance exhaust listed for the Holden Calais from 01/1988. Supplied through SWD, it carries a recorded recommended retail of $2,103.35.

Will it suit my Holden Calais?

This listing is for the Holden Calais from 01/1988, the upper-trim end of the range in that era. We treat it as listed to fit, not a certainty, so the first step is your exact build: send the variant and body and we will match the K-RPT14626 before ordering, since exhaust feed data on a car this age is not always precise.

What is a cat-back and what does it change?

A cat-back is the section of exhaust behind the catalytic converter — the pipe, mufflers and tailpipe. Fitting one renews that rear run and lifts the note over a tired factory muffler, while leaving the converter and front pipe as Holden fitted them. On an older Calais the honest benefit is usually fresh, complete rear metal in place of pipe that has thinned with age; we hold no sound or power data, so no figures are quoted.

What's recorded for this listing?

The K-RPT14626 carries a recorded recommended retail of $2,103.35, which is what distinguishes it within the Calais and Commodore family. Redback does not publish a pipe diameter, material grade or muffler arrangement for it in our data, so those are confirmed against the part rather than stated here.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits Redback cat-back systems in-house across the Illawarra. We check the K-RPT14626 against your actual Calais on the hoist, confirm the clearances and the joint to the cat, and book the bay — and as a heritage Holden part we confirm stock before ordering.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the K-RPT14626 fit my Holden Calais?
It is listed to fit the Holden Calais from 01/1988. Confirm your exact build with the workshop before ordering.
Does it keep the catalytic converter?
Yes. As a cat-back it renews the pipework behind the converter and leaves the cat in place.
What does it cost to supply?
The recorded RRP is $2,103.35 (AUD). As an older part it is often ordered in; we confirm availability when you enquire.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.