KB4210-XCXR

Ford Ranger PX 1 and PX 2 3.2L (P5AT) 2011 to Sept 2016 (without DPF) - Single 3"

Ford Ranger PX 1 and PX 2 3.2L (P5AT) 2011 to Sept 2016 (without DPF) - Single 3" with Centre Resonator and CAT Kit.

BrandPacemaker

Category: Mufflers and resonators

RRP $1758.60 AUD
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Ranger PX 1 and PX 2 3.2L (P5AT) 2011 to Sept 2016 (without DPF) - Single 3" with Centre Resonator and CAT Kit product image

Part specs

SKU
KB4210-XCXR
Supplier
Pacemaker
Category
Mufflers and resonators
Vehicle fitment
Ford PX 1 (2011-2015) PX 2 (2015-2018)
Stock status
Confirmed on order

Sharing the with-cat layout but tuned with a resonator, the Pacemaker KB4210-XCXR runs a 3in centre resonator and keeps the cat — listed to fit the Ford Ranger PX1 and PX2 3.2L P5AT turbo-diesel (2011 to September 2016). It leads on its resonator: a drone-targeting section rather than a broad silencer, with the emissions hardware retained.

Resonator with the cat retained

This XCXR keeps the catalytic converter and uses a centre resonator instead of a chambered muffler. A resonator cancels the narrow diesel drone band that reaches the cabin at cruise, rather than damping across the range, so it cleans the note while staying freer-flowing than a muffler — with the cat kept in place.

Why 3in on the P5AT?

The 3in bore suits the 3.2-litre five-cylinder P5AT, trimming factory tailpipe restriction once the turbo is spooled. We list the 3in figure as Pacemaker publishes it and quote no kW or decibel data, which isn't supplied.

Road use and fitment

It's listed to fit the Ford Ranger PX1 and PX2 3.2L P5AT from 2011 to September 2016; confirm your exact build with the workshop before ordering. Because the cat is retained the factory emissions hardware stays in place, but we make no ADR-compliance claim — confirm your state's requirements first.

Pricing and fitting at Oak Flats

Oak Flats Muffler Men fits these Ranger kits across the Illawarra. The KB4210-XCXR carries an RRP of $1,758.60, reflecting the included cat, and it may be special-ordered; we'll confirm stock and timing, then check clearance to the body and that every hanger lines up across the section before sign-off when you book.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the KB4210-XCXR keep the cat?
Yes — this is the with-cat resonator build, so the factory catalytic converter is retained.
Muffler or resonator?
It uses a centre resonator, which targets cruise drone rather than damping volume broadly.
Will it fit my PX Ranger?
It's listed to fit the Ford Ranger PX1 and PX2 3.2L P5AT from 2011 to September 2016; confirm your build with the workshop.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.