PP4170-02

Ford Falcon GT FG and FG-X XR8 5.0L Supercharged Coyote Cat Back System - No Centre

Pacemaker Ford Falcon GT FG and FG-X XR8 5.0L Supercharged Coyote Cat Back System - No Centre Muffler - with Duel Rear Muffler and Quad Tip.

BrandPacemaker

Category: Mufflers and resonators

RRP $2132.01 AUD
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Falcon GT FG and FG-X XR8 5.0L Supercharged Coyote Cat Back System - No Centre Muffler -  with Duel Rear Muffler and Quad Tip Outlet product image

Part specs

SKU
PP4170-02
Supplier
Pacemaker
Category
Mufflers and resonators
Vehicle fitment
Ford FG X
Stock status
Confirmed on order

The Pacemaker PP4170-02 takes the centre muffler out of the supercharged-Coyote cat-back: built for the Ford Falcon GT and XR8 (FG and FG-X, 5.0L supercharged Coyote), it deletes the centre silencer but keeps dual rear mufflers and a quad-tip outlet, so it's louder than stock with rear silencing retained.

Why delete the centre muffler on the blown V8?

Removing the centre muffler opens the mid-section of the cat-back, so the 5.0L supercharged Coyote finds more voice, while the two rear mufflers keep it short of a fully raw note. The quad-tip outlet caps it off. It's the louder-than-stock middle ground against the fully rear-silenced version in this FG/FG-X family.

Where does a cat-back sit?

A cat-back is the run from behind the catalytic converters to the tips — mid-pipes, mufflers and tailpipes — with converters and engine-side hardware left in place. It's the part changed to alter road-car flow and sound without touching front-end emissions equipment.

Is it listed for my FG/FG-X XR8?

The PP4170-02 is listed to fit the Ford Falcon GT and XR8 across FG and FG-X with the 5.0L supercharged Coyote V8. These builds vary in detail, so send yours to Oak Flats Muffler Men and we'll confirm the fitment before you order.

What does fitting involve in the Illawarra?

Our Oak Flats workshop fits this from the converter flanges back, routing the centre-delete mid-pipe, hanging both rear mufflers and aligning the quad tips in the valance. We check tank and subframe clearance and set tip sit before final tightening. Compliance specifics aren't supplied with the part — confirm registration requirements with us.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the PP4170-02 still have rear silencing?
Yes — only the centre muffler is deleted; twin rear mufflers remain, so it's louder than stock but not fully straight-through.
What's the outlet style?
A quad-tip outlet fed by the dual rear mufflers.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.