KBD9420-XXMX

Nissan Navara ST-X D23 2.3L TD March 2015 to current (Factory DPF/Air Purifier Back)

Nissan Navara ST/ST-X D23 2.3L TD March 2015 to current (Factory DPF/Air Purifier Back) - 3" Exhaust Kit.

BrandPacemaker

Category: Complete exhaust systems

RRP $1351.59 AUD
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Nissan Navara ST/ST-X D23 2.3L TD March 2015 to current (Factory DPF/Air Purifier Back) - 3" Exhaust Kit product image

Part specs

SKU
KBD9420-XXMX
Supplier
Pacemaker
Category
Complete exhaust systems
Vehicle fitment
Nissan D23 (NP300)
Stock status
Confirmed on order

The Pacemaker KBD9420-XXMX is a 3in DPF-back exhaust kit listed to fit the Nissan Navara ST and ST-X (D23) with the 2.3L turbo-diesel, from 2015. It picks up behind the factory diesel particulate filter and runs to the tailpipe.

What does this Navara kit cover?

This 3in kit is matched to the D23 Navara in ST and ST-X trim with the 2.3L turbo-diesel, picking up at the rear of the factory diesel particulate filter and carrying through to the tailpipe. The two grades share the same fitment here. What the catalogue doesn't state is the material or the muffler layout, and rather than invent either we confirm them against the kit on the bench before it goes near the ute.

What is a DPF-back system and what does it change?

A DPF-back swap leaves the particulate filter and all the emissions plumbing ahead of it in place, and replaces only the run behind it. On the D23's 2.3-litre diesel the point of stepping up to 3in is the rear flow rather than volume, so the result is a deeper tailpipe note, not a crack. We can't quote a sound level because the supplier doesn't publish one, and we won't estimate it.

Will it suit my ST or ST-X Navara?

The fitment given is the Nissan Navara ST and ST-X (D23), 2.3L turbo-diesel, from 2015 onward. That run had detail changes over time, so the safe step is to confirm your specific Navara against the kit before you commit. This is listed to fit rather than guaranteed.

What does fitting involve at our Illawarra workshop?

Navara fitments are done in our own Illawarra workshop. We hang the kit from behind the filter, set the tailpipe so it clears the rear bar cleanly, and check the run for clearance along the chassis rails before the ute is signed off.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the KBD9420-XXMX a DPF-back system?
Yes. It replaces the exhaust behind the factory diesel particulate filter and leaves the DPF in place.
Which Navara does it fit?
It's listed to fit the Nissan Navara ST and ST-X (D23) with the 2.3L turbo-diesel from 2015. Confirm your build with the workshop.
Is it a 3in kit?
Yes, it's a 3in system. Material and muffler details aren't published by the supplier, so we confirm them from the kit.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.