PP5367-30

HSV VZ 6.0L 8 Cylinder Ute Try-Y Headers 2 1/2 Inch System

HSV VZ 6.0L 8 Cylinder Ute Try-Y Headers 2 1/2 Inch System.

BrandPacemaker

Category: Extractors and headers

RRP $4321.46 AUD
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
HSV VZ 6.0L 8 Cylinder Ute Try-Y Headers 2 1/2 Inch System product image

Part specs

SKU
PP5367-30
Supplier
Pacemaker
Category
Extractors and headers
Vehicle fitment
Hsv Vz
Stock status
Confirmed on order

The Pacemaker PP5367-30 brings the Tri-Y header layout to the HSV VZ 6.0L eight-cylinder ute, supplied as the header and front section, staged paired runners for a broad torque character.

What does the Tri-Y merge give the 6.0L VZ ute?

Rather than feeding four runners into one collector, the Tri-Y pairs them and merges in two stages, which tends to build a fuller torque spread through the low and mid-range. On a heavier 6.0L VZ ute that's the usable end of the rev range, and the PP5367-30 puts that layout in place of the cast manifold.

What does the system cover?

This is the header and front section for the HSV VZ 6.0L ute, replacing the manifolds and tying into the cat and rear sections behind it. The ute body shapes the front routing, so the pipework clears that floorpan and front end.

Will it suit my HSV VZ 6.0L ute?

It's listed to fit the HSV VZ 6.0L eight-cylinder ute. Tri-Y fitment is tight to body and driveline, so confirm your exact VZ ute and that it's the 6.0L with the workshop before ordering.

Fitting at our Illawarra workshop

Oak Flats Muffler Men fits Pacemaker Tri-Y systems in-house across the Illawarra. We check ute clearances and routing, fit fresh gaskets and tie the header into the cat and rear sections that carry on behind it. As a Pacemaker special-order item it's brought in rather than held on the shelf, so we confirm your exact 6.0L VZ ute before the part is sourced. Recommended retail is $4,321.46 AUD, confirmed before ordering.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Why a Tri-Y header?
Its two-stage merge favours broad low and mid-range torque, suited to a heavier 6.0L ute. The PP5367-30 is the header and front section.
What does it fit?
The HSV VZ 6.0L eight-cylinder ute. Confirm your exact build with the workshop first.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.