PP5387-05

HSV VF 8 Cylinder 6.0L / 6.2L Gen IV, LS2, LS3, Tri-Y Headers 2 1/2 Inch System

HSV VF 8 Cylinder 6.0L / 6.2L Gen IV, LS2, LS3, Tri-Y Headers 2 1/2 Inch System.

BrandPacemaker

Category: Extractors and headers

RRP $4403.42 AUD
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
HSV VF 8 Cylinder 6.0L / 6.2L Gen IV, LS2, LS3, Tri-Y Headers 2 1/2 Inch System product image

Part specs

SKU
PP5387-05
Supplier
Pacemaker
Category
Extractors and headers
Vehicle fitment
Hsv Vf
Stock status
Confirmed on order

The Pacemaker PP5387-05 uses a tri-Y header design feeding a 2½ in system, listed to fit the HSV VF 8-cylinder 6.0L/6.2L (Gen IV LS2/LS3). The tri-Y merge layout is what sets this set apart from a 4-into-1.

Tri-Y versus 4-into-1 — what's the difference?

A tri-Y header pairs the primaries and merges them in two stages rather than gathering all four into a single collector. The staged merge tends to broaden the torque character lower and through the mid-range, which is why a tri-Y is often the choice for a street-driven V8 over a single-plane 4-into-1. Here it feeds a 2½ in system on the VF Gen-IV V8.

What does the 2½ in system pairing suit?

Pacemaker matches the tri-Y to a 2½ in run for the VF V8. The 2½ in diameter keeps the package balanced with the tri-Y's mid-range bias rather than oversizing the pipe; we fit it as the matched pair.

Will it suit my VF V8?

It's listed to fit the HSV VF 8-cylinder 6.0L/6.2L (Gen IV LS2/LS3); no body or year is published on this listing, so we confirm fit against your exact car before ordering. Bring the VIN and we'll check it.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men fits these tri-Y Pacemaker headers across the Illawarra. We match the listing to your VF, remove the cast manifolds, fit the tri-Y headers and the 2½ in system on fresh gaskets, and check clearances. RRP is listed at 4403.42 AUD; fitting is quoted on the vehicle.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What's a tri-Y header?
It pairs the primaries and merges them in two stages rather than a single 4-into-1, which tends to broaden low and mid-range torque on a street V8.
What system size does the PP5387-05 run?
A 2½ in system, matched by Pacemaker to the tri-Y headers for the VF V8.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.