RL788

RL788 Leaf Spring for Holden Colorado RG I UTE / Dual CAB

RL788 Leaf Spring. Quality guaranteed.

BrandRAW 4x4

Category: Suspension and 4x4 parts

RRP pending
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
RL788 Leaf Spring for Holden Colorado RG I UTE / Dual CAB product image

Part specs

heights
['40mm']
positions
['Rear']
shock_types
[]
vehicle_count
5

The RAW 4x4 RL788 is a rear leaf spring listed to fit the Holden Colorado RG I dual-cab ute — the load-bearing pack that supports the tray and holds the rear of the chassis at height.

What a leaf spring does on the RG I

On a ladder-frame ute the rear leaf spring carries the payload, supports the body and locates the axle, flexing over every bump as it works. Years of load flatten its arch and let the rear sag. The RL788 is RAW 4x4's replacement leaf pack for the first-generation Holden Colorado RG, restoring the rear's ability to sit at height and carry weight where the originals have tired out.

Does the RL788 match my load?

The right leaf pack depends on how the Colorado is used, and RAW 4x4 doesn't publish a load rating for the RL788 in this record. If you tow, run a canopy or carry a regular tray load, tell the workshop how the ute is set up and we'll confirm the RL788 suits before ordering, rather than guessing a rate. The record also associates this part with Isuzu and LDV platforms.

Leaf-pack fitting in the Illawarra

Oak Flats Muffler Men supplies and fits RAW 4x4 leaf springs across the Illawarra. Replacing a pack means dropping the axle, swapping the leaves and re-checking the U-bolts, shackles and bushes — parts worth renewing at the same time. It's listed to fit the Colorado RG I dual-cab; confirm your build with the workshop.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the RL788 fix a sagging rear?
A fresh leaf pack restores the height a tired original has lost. RAW 4x4 doesn't list a specific lift figure here, so confirm the height and load you need with the workshop.
Is the RL788 only for the Holden Colorado?
It's listed for the Holden Colorado RG I dual-cab and the record also associates it with Isuzu and LDV platforms. Confirm your exact vehicle with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.