RL969

RL969 Leaf Spring for Foton Tunland Ute/dual CAB

RAW 4x4 RL969 Leaf Spring for Foton Foton Tunland Ute/dual CAB.

BrandRAW 4x4

Category: Suspension and 4x4 parts

RRP pending
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
RL969 Leaf Spring for Foton Foton Tunland Ute/dual CAB product image

Part specs

heights
['40mm']
positions
['Rear']
shock_types
[]
vehicle_count
3

Payload over the rear axle is what a leaf pack is built to carry, and the RAW 4x4 RL969 is the rear spring for that job — listed to fit the Toyota Hilux ute dual cab.

What does the rear leaf pack control?

On a leaf-sprung ute the rear pack both supports the load and locates the axle fore-and-aft. The RL969 is that rear spring: it sets how the tray sits and how much weight the back can take before it settles low. Damping is a separate job handled by the shock absorbers, so replacing the leaf pack addresses load support and ride height, not bump control. The supplier hasn't published a capacity, arch or lift figure in our record, so we don't quote any.

Is the RL969 a load spring or a lift spring?

RAW 4x4 hasn't listed a rated capacity or lift height against this part number in the record we hold, so we won't pin it as one or the other. Packs in this category are commonly chosen for constant load, towing or a modest rear lift, but the exact intent for the RL969 is confirmed with the supplier before order rather than read off the title.

Will it suit my ute?

It's listed to fit the Toyota Hilux ute dual cab. Rear spring fitment depends on the exact build, axle and any existing accessories, so send us your variant and we'll confirm the RL969 is the right pack before we order it in.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits suspension parts like this in-house across the Illawarra. A rear leaf change means supporting the axle, swapping the pack and resetting the U-bolts and shackles; we check the rear height and the related bushes while it's apart, and confirm the part suits the vehicle first.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the RL969 fit my ute?
It's listed to fit the Toyota Hilux ute dual cab. Confirm your exact variant with the workshop before ordering, as rear spring fitment varies by build.
Is a load capacity published for this spring?
No — RAW 4x4 doesn't list a rated capacity, arch or lift figure for the RL969 here. We confirm the spec with the supplier before we order it in for you.
Will I need new U-bolts or bushes too?
Often worth doing while the pack is out. We assess the shackles, bushes and U-bolts during fitting and advise if anything needs replacing.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.