RPE608VEFS-PO

Redback Dual 3" Catback Exhaust for Holden Commodore VE & VF Sedan / W

Redback Dual 3" Catback Exhaust.

BrandRedbackSWD

Category: Complete exhaust systems

RRP $1651.97 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Dual 3" Catback Exhaust for Holden Commodore VE & VF Sedan / W product image

Part specs

Exit
Twin Out
Coating
Premium Heat-Proof Paint
Muffler Option
Pipe Only (Loud)
Material Type
409 Stainless Steel
Tube Size
076mm (3")
Warranty
5
Vehicle Make
Holden

The Redback RPE608VEFS-PO is a dual 3in cat-back exhaust listed to fit the Holden Commodore VE and VF sedan. It replaces the system from the catalytic converter back, so it's a rear-section upgrade rather than a tailpipe swap.

What does this cat-back system cover?

A cat-back replaces the exhaust from the catalytic converter rearward — mufflers, pipework and tips — and leaves the factory cat and front pipes untouched. On the RPE608VEFS-PO that span is run as a dual 3in layout, the twin-pipe arrangement that suits the Commodore's rear-wheel-drive layout. Because it starts behind the cat, it changes the note and the rear plumbing without touching the engine's emissions hardware up front.

Will it suit my Holden Commodore?

It's listed to fit the Holden Commodore VE and VF in sedan form. Across the VE and VF run Holden offered several drivetrains and the sedan shares its underbody with other body styles, so the safest path is to send your exact build, year and variant to the workshop and have the fitment confirmed against this part before you order.

Is it road legal?

This is a cat-back, which means the factory catalytic converter and the emissions equipment ahead of it stay in place. Road compliance still depends on noise and the rest of your build, so confirm any state requirements with the workshop before fitting rather than assuming a particular outcome.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits cat-back systems like this in-house across the Illawarra. We check clearances over the rear axle and around the tank, confirm the dual 3in pipework hangs cleanly, and set the tips. Listed to fit the Commodore VE and VF sedan; confirm the exact build with the workshop and we'll book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the RPE608VEFS-PO fit my Holden Commodore?
It's listed to fit the Holden Commodore VE and VF sedan. Confirm your exact variant and drivetrain with the workshop before ordering, as feed fitment data can be imperfect.
Does this replace the catalytic converter?
No. It's a cat-back, so it replaces the system from the catalytic converter rearward and leaves the factory cat in place.
What pipe size is it?
It's a dual 3in cat-back. The diameter beyond that isn't published in our record, so the workshop will confirm the spec on request.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.