RPE608VEFS-PO

Redback Dual 3" Catback Exhaust for Holden Commodore VE & VF Sedan / Wagon

Redback Redback Dual 3" Catback Exhaust.

BrandRedbackRedback Exhausts

Category: Complete exhaust systems

RRP $1651.97 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Dual 3" Catback Exhaust for Holden Commodore VE & VF Sedan / Wagon product image

Part specs

SKU
RPE608VEFS-PO
Supplier
Redback Exhausts
Category
Complete exhaust systems
Vehicle fitment
holden
Stock status
In stock at supplier

The Redback RPE608VEFS-PO is a dual 3in cat-back exhaust listed to fit the Holden Commodore VE and VF Sedan and Wagon. It replaces the system from behind the catalytic converter rearward, as a twin 3in run.

What does this system cover?

This is a cat-back run, meaning it replaces the exhaust from behind the catalytic converter to the tailpipe — leaving the factory cat in place. It's a dual 3in layout for the VE and VF Commodore in Sedan and Wagon body styles. The material isn't published in the record, so that detail is confirmed by the workshop rather than claimed here.

What is a cat-back system and what does it change?

A cat-back is the section behind the catalytic converter: the centre and rear pipework, mufflers and tailpipes. Because it keeps the factory cat, it's the common upgrade path on a road sedan, changing the rear of the system rather than the emissions hardware. Running it as a dual 3in layout gives twin outlets at the back. The trade-off is that it changes flow and the note from the cat back only — louder than stock — not the front of the system.

Will it suit my Commodore VE or VF?

It's listed to fit the Holden Commodore VE and VF in Sedan and Wagon forms, with three concrete fitment entries recorded. These platforms span several variants, so send your exact build and we'll confirm the dual 3in routing and rear clearance before ordering.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men fits dual cat-back systems like this in-house across the Illawarra. We confirm the cat connection, hanger points and rear clearance on your VE or VF, then book the bay. Recommended retail is $1,651.97.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What does the RPE608VEFS-PO replace?
It's a dual 3in cat-back, so it replaces the exhaust from behind the catalytic converter to the tailpipe. The factory cat stays in place.
Which Commodores does it fit?
It's listed to fit the Holden Commodore VE and VF Sedan and Wagon, with three concrete fitment entries. Confirm your exact build with the workshop.
What diameter is it?
It's a dual 3in system, the figure published in the listing.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.