SSMKFD0308

FORD MUSTANG V8 FN 2018+ 3in FULL SYSTEM WITHOUT CENTRE MUFFLER WITH REAR MUFFLERS

FORD MUSTANG V8 FN 2018+ 3in FULL SYSTEM WITHOUT CENTRE MUFFLER WITH REAR MUFFLERS & QUAD TIPS.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $6047.06 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
FORD MUSTANG V8 FN 2018+ 3in FULL SYSTEM WITHOUT CENTRE MUFFLER WITH REAR MUFFLERS & QUAD TIPS product image

Part specs

SKU
SSMKFD0308
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

Deleting the centre muffler is the defining move of the MPI Automotive SSMKFD0308 — a 3in full system listed to fit the FN Ford Mustang V8 from 2018, finishing through quad tips. With only rear mufflers left in the run, it's the freer-flowing FN build.

What does dropping the centre muffler change?

Leaving the centre muffler out clears a chambered restriction from the middle of the system, so the mid-section flows more freely and the V8 note opens up. The rear mufflers stay in to keep the tailpipe end in check, and the quad tips carry the FN's signature four-outlet look. The result is a fuller, harder note than a system with a centre muffler, without going to a fully straight-through design.

Why a 3in full system on the FN V8?

At 3in front to back, the pipework is sized for the FN Mustang's V8 rather than a tailpipe-only swap. Pairing the centre-delete with rear mufflers gives the louder-but-managed character — the choice for an FN owner who wants more voice than a quieter build allows while keeping the rear silencing. It's listed for the FN body from 2018, so the quad-tip exit is cut for that car.

Will it suit my FN Mustang?

It's listed to fit the FN Ford Mustang V8 from 2018. Confirm your exact build year and rear setup with the workshop before ordering — the quad-tip fitment depends on the bodywork, and we verify the match rather than trusting feed data alone.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits full Mustang systems like this in-house across the Illawarra. We'll confirm hanger points, the rear muffler positions, the centre-delete routing and the quad-tip alignment for your FN before booking the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the SSMKFD0308 louder than a build with a centre muffler?
It deletes the centre muffler and keeps only the rear mufflers, so it's freer through the middle and a fuller, harder note. No decibel figure is published.
What tips does it use?
It finishes through quad tips, suited to the FN Mustang's four-outlet rear styling.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.