SSMKTY0336

HFD-VDJ79 V8 4.5L TD, (DPF) Ute 2016 To Current, 4in Dual With Cat & Without Muffler

HFD-VDJ79 V8 4.5L TD, (DPF) Ute 2016 To Current, 4in Dual With Cat & Without Muffler (SKU: SSMKTY0336) Engineered.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $6245.89 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
HFD-VDJ79 V8 4.5L TD, (DPF) Ute 2016 To Current, 4in Dual With Cat & Without Muffler product image

Part specs

SKU
SSMKTY0336
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Toyota
Stock status
In stock at supplier

The MPI Automotive SSMKTY0336 is a 4in dual system for the DPF-model Toyota VDJ79 V8 4.5L turbo-diesel ute (2016 onward) that keeps the catalytic converter but runs without a muffler. The combination is its signature: it retains the cat for the emissions side while leaving the muffler out for an open, free-flowing path.

Cat retained, no muffler — what does that mix do?

Keeping the catalytic converter means the emissions hardware that matters most for road compliance stays in place, while dropping the muffler opens the path for a louder, harder note than a muffled build. There is no chambered body to absorb sound, so the character is raw, but the converter is still doing its job. It is the with-cat, no-muffler point in this VDJ79 dual range.

Why a 4in dual on the VDJ79?

This is a 4in dual layout — the largest bore in this family — sized for the 4.5L turbo-diesel V8. The dual routing splits the flow at the rear, and the 4in pipe gives the gases room from the engine back. It is the high-flow configuration for a VDJ79 ute that keeps its converter.

Is it road legal?

Because the SSMKTY0336 retains the factory catalytic converter, it leaves the converter the ute left the factory with in place. Road compliance on a DPF-model diesel also depends on the rest of the emissions hardware, so confirm your exact VDJ79 build and any NSW requirements with the workshop before fitting.

How do we fit it at the workshop?

Oak Flats Muffler Men supplies and fits VDJ79 dual systems across the Illawarra. The SSMKTY0336 is listed to fit the DPF-model VDJ79 V8 4.5L ute from 2016 onward; bring us your build and we will confirm the dual routing and clearances before booking the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the SSMKTY0336 keep the catalytic converter?
Yes. This is the with-cat configuration, so the factory catalytic converter stays in place; only the muffler is left out.
Will it suit my VDJ79 V8 ute?
It is listed to fit the DPF-model Toyota VDJ79 V8 4.5L turbo-diesel ute from 2016 onward. Confirm your exact build with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.