BSK1004

BSK1004 Bush/shackle/pin/u Bolt KIT for Great Wall V Series V200, V240 UTE / Dual CAB

BSK1004 Bush/shackle/pin/u Bolt KIT.

BrandRAW 4x4

Category: Suspension and 4x4 parts

RRP pending
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
BSK1004 Bush/shackle/pin/u Bolt KIT for Great Wall V Series V200, V240 UTE / Dual CAB product image

Part specs

heights
[]
positions
['Rear']
shock_types
[]
vehicle_count
4

When you swap leaf springs you should renew the hardware that holds them, and the RAW 4x4 BSK1004 is a bush, shackle, pin and U-bolt kit listed to fit the Great Wall V-Series V200 and V240 dual-cab ute. It's the consumables-and-mounts set for the rear leaf installation.

What's in a bush, shackle, pin and U-bolt kit?

This kit covers the mounting hardware for a rear leaf pack: the bushes that cushion the spring eyes and shackles, the shackle and pin assemblies that let the spring articulate, and the U-bolts that clamp the pack to the axle. These parts wear, perish and stretch over time, and they're the items that should be renewed whenever leaf springs are replaced so the new pack is held the way it should be.

Why fit the BSK1004 with new springs?

Reusing tired bushes, worn shackles or stretched U-bolts on a fresh leaf pack undoes much of the benefit — the spring can move where it shouldn't and the install won't hold torque properly. The BSK1004 is RAW 4x4's matched hardware kit for the Great Wall V-Series, so the rear end goes back together with sound mounts rather than mixed old-and-new components.

Fitting at our Illawarra workshop

Oak Flats Muffler Men fits RAW 4x4 suspension hardware across the Illawarra, and this kit is most logically installed alongside a leaf-spring change. It's listed to fit the Great Wall V-Series V200 and V240 dual-cab; confirm your exact build with the workshop, since some kit contents vary by configuration and we'll match the correct set.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Do I need the BSK1004 if I'm just replacing leaf springs?
It's strongly recommended. New springs on old bushes, shackles and U-bolts won't perform or hold up as they should. We'll advise during the job.
Does the kit suit the V200 and V240?
Yes — it's listed to fit the Great Wall V-Series V200 and V240 dual-cab ute. Confirm your exact configuration with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.