RL886

RL886 Leaf Spring for Great Wall V Series V200, V240 UTE / Dual CAB

RL886 Leaf Spring.

BrandRAW 4x4

Category: Suspension and 4x4 parts

RRP pending
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
RL886 Leaf Spring for Great Wall V Series V200, V240 UTE / Dual CAB product image

Part specs

heights
['40mm']
positions
['Rear']
shock_types
[]
vehicle_count
4

The rear of a working ute lives and dies by its leaf pack, and the RAW 4x4 RL886 is a replacement leaf spring listed to fit the Great Wall V-Series V200 and V240 dual-cab. It carries the load and sets rear ride height on the V-Series chassis.

What does a leaf spring do on the V-Series?

A leaf spring is the rear suspension's main load-bearing element on a ladder-frame ute — a stack of curved steel leaves that supports the tray, the payload and the vehicle's own weight while allowing the axle to move. Over time and under constant load, leaves sag, lose their arch and let the rear sit low. The RL886 is RAW 4x4's replacement pack for the Great Wall V-Series, restoring the rear's ability to hold its height and carry weight.

Is this the right leaf for my load?

Leaf packs are chosen to match how the ute is used, and RAW 4x4 doesn't publish a load rating for the RL886 in this record. If you're running a canopy, tow weight or a regular tray load, tell us how the V-Series is set up and we'll confirm the RL886 suits before ordering, rather than guessing at a rate.

Fitting a leaf pack at our Illawarra workshop

Oak Flats Muffler Men fits RAW 4x4 leaf springs in-house across the Illawarra. Replacing a leaf pack means dropping the axle, swapping the springs and re-checking the U-bolts, shackles and bushes — components worth inspecting at the same time. It's listed to fit the V-Series V200 and V240 dual-cab; confirm your exact build with the workshop.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the RL886 raise the rear of my V-Series?
A fresh leaf pack restores the height a sagged original has lost. RAW 4x4 doesn't list a specific lift figure for the RL886 here, so confirm the height and load you need with the workshop.
What else should be replaced with the leaf springs?
U-bolts, shackle bushes and pins are worth checking whenever the leaf pack comes out. We'll inspect them during fitting and advise if they need doing.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.