
Redback Performance Headers and 2.5" Exhaust System for Holden Commodore
Redback ExhaustsRRP$2613.75Redback Performance Headers and 2.5" Exhaust System.
View part
Redback Manifold Catalytic Converter.
Category: Extractors and headers


The Redback C2843 is a manifold catalytic converter listed to fit the Holden Colorado from 2008 — a one-piece manifold-and-converter section sized for a working ute's hot, hard-run front end.
It replaces the integrated front section: the exhaust manifold off the engine plus the catalytic converter, built as a single assembly. On a 2008 Colorado that runs loaded and hot, this is the part that takes the worst of the heat-cycle stress, so a cracked manifold or a spent converter is usually cured by renewing the whole unit. No diameter or material is published, so we don't state either.
It's listed to fit the Holden Colorado from 2008, with three concrete fitments on the listing. The supplier doesn't publish the engine here, so we treat the match as listed-to-fit and confirm it against your VIN and driveline before the part is ordered.
Because the C2843 is the catalytic-converter section, fitting it restores the Colorado's emissions hardware rather than deleting it. Registrability depends on the rest of the system's condition, which we inspect on the hoist. We won't claim a compliance approval the supplier hasn't published.
Oak Flats Muffler Men fits Colorado manifold-cats in-house across the Illawarra. We confirm the listing against your build, work the old assembly off the engine, fit fresh gaskets, and reset any sensors the job disturbs. RRP is listed at 685 AUD; labour is quoted once the ute is in the bay.
Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.
Oak Flats Muffler Men can check this part against supplier specs, part number, image, RRP and vehicle details for customers around Oak Flats, Shellharbour, Wollongong, Dapto, Albion Park, Kiama and the northern suburbs.
Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.