MBM229MF

Ford Falcon AU V8 Sedan IRS Dual 2 1/2in Rear Muffler

Ford Falcon AU V8 Sedan IRS Dual 2 1/2in Rear Muffler (SKU: MBM229MF) Engineered for selected vehicle.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $618.42 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Falcon AU V8 Sedan IRS Dual 2 1/2in Rear Muffler product image

Part specs

SKU
MBM229MF
Supplier
MPI Automotive
Category
Mufflers and resonators
Stock status
In stock at supplier

The MPI Automotive MBM229MF is a dual rear muffler listed to fit the IRS Ford Falcon AU V8 sedan. As the rearmost dual silencer, it sets the tailpipe note and is matched to the independent-rear-suspension floorpan.

What does a dual rear muffler do here?

A rear muffler is the last silencer before the tailpipe, so it has the most say in what you hear at the bumper. Running a dual layout means a muffler on each pipe of the twin system, quietening both banks of the V8 close to the exit. As chambered units they work by absorption and reflection inside the body, keeping cruise drone down while letting the V8 note through. It is the rear section only, paired with your centre and front pipework.

Why the IRS callout?

This part is listed for the IRS Ford Falcon AU V8 sedan. Independent rear suspension changes the rear floorpan and what the exhaust routes around compared with a live-axle car, so the dual rear is shaped to clear that IRS hardware and hang correctly. If your AU is a live-axle car, this is not the right listing — confirm your rear setup with the workshop before ordering.

What size is it?

It is built on a 2in bore, the supplier's figure for this listing and the only size we state. That matches the AU's twin rear pipework rather than a bigger-bore custom run. We do not state any measurement the record does not give, so confirm your pipe size with the workshop if your car has been modified.

What does fitting involve in the Illawarra?

Oak Flats Muffler Men fits Falcon dual rear mufflers in-house across the Illawarra. We mount both units to your AU's IRS hangers, check clearance to the suspension and tailpipe exit, and confirm the section lines up before booking you in.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the MBM229MF fit my live-axle AU?
No — it is listed for the IRS Ford Falcon AU V8 sedan, which uses a different rear floorpan. Confirm your rear setup with the workshop.
Is this a rear or centre muffler?
It is the dual rear muffler — the last silencer before the tailpipe, with a muffler on each pipe of the twin system.
What bore is it?
It is built on a 2in pipe, the supplier's figure for this listing.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.